When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Preferred metric sizes - Wikipedia

   en.wikipedia.org/wiki/Preferred_metric_sizes

   Machine screws with different thread diameters Hex key set with metric sizes from 2 mm to 10 mm according to sizes for use with ISO 262 screw sizes (except 3.5 mm for M6 internal set screw) For each size bolt or screw and type of head, there is a corresponding size driver prescribed by various ISO standards, including:

3. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Example (inch, coarse): For size 7 ⁄ 16 (this is the diameter of the intended screw in fraction form)-14 (this is the number of threads per inch; 14 is considered coarse), 0.437 in × 0.85 = 0.371 in. Therefore, a size 7 ⁄ 16 screw (7 ⁄ 16 ≈ 0.437) with 14 threads per inch (coarse) needs a tap drill with a diameter of about 0.371 inches.

4. British Standard Cycle - Wikipedia

   en.wikipedia.org/wiki/British_Standard_Cycle

   BS 811: 1950 provides specifications for British standard cycle threads. [2] Cycle thread in 7 ⁄ 16 and 1 ⁄ 2 inch sizes also come in 20 tpi and 24 tpi options. 1/4" diameter cycle thread nuts and bolts have the same 26tpi as 1/4" BSF, which means that they will fit each other in this diameter only. Traditionally the parts it would be found ...

5. Unified Thread Standard - Wikipedia

   en.wikipedia.org/wiki/Unified_Thread_Standard

   The major diameter may be slightly different from the shank diameter, which is the diameter of the unthreaded part of the screw. The diameters are sometimes given approximately in fractions of an inch (e.g. the major diameter of a #6 screw is 0.1380 in, approximately 9 ⁄ 64 in = 0.140625 in. The pitch P is the distance between thread peaks.

6. British Standard Fine - Wikipedia

   en.wikipedia.org/wiki/British_Standard_Fine

   British Standard Fine (BSF) is a screw thread form, as a fine-pitch alternative to British Standard Whitworth (BSW) thread. It was used for steel bolts and nuts on and in much of Britain's machinery, including cars, prior to adoption of Unified, and later Metric, standards.

7. Screw thread - Wikipedia

   en.wikipedia.org/wiki/Screw_thread

   The nominal diameter of Metric (e.g. M8) and Unified (e.g. 5 ⁄ 16 in) threads is the theoretical major diameter of the male thread, which is truncated (diametrically) by 0.866 ⁄ 4 of the pitch from the dimension over the tips of the "fundamental" (sharp cornered) triangles.