Ad
related to: inline roller switch for lamp bulb kit diagram pdf free
Search results
Results From The WOW.Com Content Network
A lightbulb socket, lightbulb holder, light socket, lamp socket or lamp holder is a device which mechanically supports and provides electrical connections for a compatible electric lamp base. [1] Sockets allow lamps to be safely and conveniently replaced (re-lamping).
Bulbs used for headlamps, turn signals and brake lamps may be required to comply with international and national regulations governing the types of lamps used. Other automotive lighting applications such as auxiliary lamps or interior lighting may not be regulated, but common types are used by many automotive manufacturers.
Portable lamps such as table lamps may have a light switch mounted on the socket, base, or in-line with the cord. Manually operated on/off switches may be substituted by dimmer switches that allow controlling the brightness of lamps as well as turning them on or off, time-controlled switches, occupancy-sensing switches, and remotely controlled ...
A shunt resistor, which has been connected in parallel across the filament before it burnt out, will then short out to bypass the burnt filament and allow the rest of the string to light. If too many lights burn out however, a shunt will also burn out, requiring the use of a multimeter to find the point of failure.
Device for Connection of Luminaires (DCL) is a European standard for ceiling light fixtures introduced in 2005 and refined in 2009. It uses 6 ampere. DCL must carry the CE marking as per the Low Voltage Directive. DCL is only allowed to be installed with ground. Example of DCL socket.
In contrast to a simple light switch, which is a single pole, single throw (SPST) switch, multiway switching uses switches with one or more additional contacts and two or more wires are run between the switches. When the load is controlled from only two points, single pole, double throw (SPDT) switches are used.
They enable computer control via networked switches, but do not require it. Their cost is about the same as the older "dimmability" circuitry that they replace in LED bulbs, fixtures or drivers. A residential-type dimmer switch with sliding knob to change brightness. The device is small enough to fit into a regular wall box provided for a switch.
Fog light (also called foglamp) Spotlight; Headlight (also called headlamp) Headlight motor; Interior light and lamp, Center dome, Vanity-Sun visor and rear side, Floor and Door-front, back, Boot lamp or Trunk lamp; License plate lamp (also called number plate lamp or registration plate lamp) Side lighting; Brake light, Third or Center Brake ...