When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Punch (tool) - Wikipedia

   en.wikipedia.org/wiki/Punch_(tool)

   A drift punch is constructed as a tapered rod, with the hammer acting on the large end of the taper. The long end of a drift punch is placed into the semi-aligned bolt holes of two separate components, and then driven into the hole. As it is driven in, the taper forces the two components into alignment, allowing for easy insertion of the fastener.

3. Drift pin - Wikipedia

   en.wikipedia.org/wiki/Drift_pin

   A drift is smaller in diameter than the hammer face, thus concentrating the force into a smaller area. A drift is also used where the surrounding surfaces need to be protected from the hammer blow. [1] A drift is not used as a punch in the traditional sense of the term. Unlike most punches, force should never be applied to the tip of drift pin.

4. Knockout punch - Wikipedia

   en.wikipedia.org/wiki/Knockout_punch

   Chassis punches: assorted sizes round and square Chassis punches: assorted sizes round and square disassembled. In metalworking, a knockout punch, also known as a chassis punch, panel punch, Greenlee punch, or a Q-max, [1] is a hand tool used to punch a hole through sheet metal. It is a very simple tool that consists of a punch, die, and screw.

5. Impact driver - Wikipedia

   en.wikipedia.org/wiki/Impact_driver

   A manual impact driver (for use with hammer) with screwdriver bits and adapters. An impact driver is a tool that delivers a strong, sudden rotational force and forward thrust. The force can be delivered either by striking with a hammer in the case of manual impact drivers, or mechanically in the case of powered impact drivers.

6. Automatic center punch - Wikipedia

   en.wikipedia.org/wiki/Automatic_center_punch

   The hammer has a hole through its center that the top of the punch sits in, and holds the top of the punch centered. The sliding block has a hole through it that, when reset, is misaligned with the hole through the hammer. When the body is pressed to the trip point, a taper in the body forces the block sideways until the hole in the block is ...

7. Punch press - Wikipedia

   en.wikipedia.org/wiki/Punch_press

   Quick change tool system (left: die; front: punch, split punch retainer; back: tool body; right: punch guide) A die set consists of a set of punches and dies which, when pressed together, form a hole in a workpiece (and may also deform the workpiece in some desired manner). The punches and dies are removable, with the punch being attached to ...