Ads
related to: amplifier signal satelliteamazon.com has been visited by 1M+ users in the past month
Search results
Results From The WOW.Com Content Network
A communications satellite's transponder is the series of interconnected units that form a communications channel between the receiving and the transmitting antennas. [1] It is mainly used in satellite communication to transfer the received signals. A transponder is typically composed of: an input band-limiting device (an input band-pass filter),
The signal received by the LNB is extremely weak and it has to be amplified before downconversion. The low-noise amplifier section of the LNB amplifies this weak signal while adding the minimum possible amount of noise to the signal. The low-noise quality of an LNB is expressed as the noise figure (or sometimes noise temperature). This is the ...
TWTAs are commonly used as amplifiers in satellite transponders, where the input signal is very weak and the output needs to be high power. [21] TWTAs used in satellite communications are considered as reliable choices and tend to live beyond their expected lifetime of 15-20 years. [22] A TWTA whose output drives an antenna is a type of ...
A low-noise amplifier (LNA) is an electronic component that amplifies a very low-power signal without significantly degrading its signal-to-noise ratio (SNR). Any electronic amplifier will increase the power of both the signal and the noise present at its input, but the amplifier will also introduce some additional noise.
The RF amplifier may not be needed and is often omitted (or switched off) for frequencies below 30 MHz, where the signal-to-noise ratio is defined by atmospheric and human-made noise. A local oscillator (LO) which generates a radio frequency signal at an offset from the incoming signal, which is mixed with the incoming signal.
The simplest klystron tube is the two-cavity klystron. In this tube there are two microwave cavity resonators, the "catcher" and the "buncher". When used as an amplifier, the weak microwave signal to be amplified is applied to the buncher cavity through a coaxial cable or waveguide, and the amplified signal is extracted from the catcher cavity.