When.com Web Search

  1. Ad

    related to: shell non conductive hydraulic oil equivalent table for concrete

Search results

  1. Results From The WOW.Com Content Network
  2. Equivalent Concrete Performance Concept - Wikipedia

    en.wikipedia.org/wiki/Equivalent_Concrete...

    A concrete composition not composed by the standard EN 206–1, can be acknowledged, only if the new concrete shows a performance equal to the standardized concrete concerning environmental classes. Cement content and water-cement ratio are important elements hereby. The comparison with standardized concrete is tested according to the following ...

  3. List of additives used for fracking - Wikipedia

    en.wikipedia.org/wiki/List_of_additives_used_for...

    In the United Kingdom, the environmental regulator permits only chemical additives which are classed as non hazardous to groundwater for fracturing fluids. [3] [4] [5] Operators are required to disclose the content of hydraulic fracturing fluids to the relevant environment agency [6] while the composition must be disclosed if the regulator demands it. [7]

  4. List of thermal conductivities - Wikipedia

    en.wikipedia.org/wiki/List_of_thermal_conductivities

    Yarwood and Castle have their transformer oil on page 37. Paper: Ordinary Paper Engineeringtoolbox 0.05 [5] Yarwood and Castle 0.125 [73] Oil Impregnated Paper 0.180 — 0.186 [32] 298 [5] 291.15 294.7 — 385.2 The oil-impregnated paper was about 0.05 inches thick and it was loaded under about 2 PSI. TPRC Volume 2, page 1127.

  5. Properties of concrete - Wikipedia

    en.wikipedia.org/wiki/Properties_of_concrete

    Concrete has a very low coefficient of thermal expansion, and as it matures concrete shrinks. All concrete structures will crack to some extent, due to shrinkage and tension. Concrete which is subjected to long-duration forces is prone to creep. The density of concrete varies, but is around 2,400 kilograms per cubic metre (150 lb/cu ft). [1]

  6. Drainage equation - Wikipedia

    en.wikipedia.org/wiki/Drainage_equation

    d = equivalent depth, a function of L, (Di-Dd), and r; r = drain radius (m) Steady (equilibrium) state condition In steady state, the level of the water table remains constant and the discharge rate (Q) equals the rate of groundwater recharge (R), i.e. the amount of water entering the groundwater through the watertable per unit of

  7. Non-shrink grout - Wikipedia

    en.wikipedia.org/wiki/Non-shrink_grout

    Non-shrink grout is a hydraulic cement grout that, when hardened under stipulated test conditions, does not shrink, so its final volume is greater than or equal to the original installed volume. It is often used as a transfer medium between load-bearing members.

  8. Hydraulic diameter - Wikipedia

    en.wikipedia.org/wiki/Hydraulic_diameter

    For a fully filled duct or pipe whose cross-section is a convex regular polygon, the hydraulic diameter is equivalent to the diameter of a circle inscribed within the wetted perimeter. This can be seen as follows: The N {\displaystyle N} -sided regular polygon is a union of N {\displaystyle N} triangles, each of height D / 2 {\displaystyle D/2 ...

  9. Concrete shell - Wikipedia

    en.wikipedia.org/wiki/Concrete_shell

    A concrete shell, also commonly called thin shell concrete structure, is a structure composed of a relatively thin shell of concrete, usually with no interior columns or exterior buttresses. The shells are most commonly monolithic domes , but may also take the form of hyperbolic paraboloids , ellipsoids , cylindrical sections, or some ...