Ads
related to: anti roll bar vs sway
Search results
Results From The WOW.Com Content Network
An anti-sway or anti-roll bar is intended to reduce the lateral tilt (roll) of the vehicle on curves, sharp corners, or large bumps. Although there are many variations in design, the object is to induce a vehicle's body to remain as level as possible by forcing the opposite wheel's shock absorber , spring, or suspension rod in the same ...
By altering stabilizer bar stiffness, this system acts to reduce body tilt during cornering, keeping the vehicle more level during turns and improving handling, as opposed to the natural tendency of a vehicle to roll due to the lateral forces experienced during high-speed maneuvering. The active stabilizer system relies on vehicle body sensors ...
Several engineering options can limit swing axle handling problems, with varying success: Anti-roll bar: As a design option, a front anti-roll bar which can ameliorate the swing axle car's handling—shifting weight transfer to the front outboard tyre, considerably reducing rear slip angles—thereby avoiding potential oversteer.
The anti-roll bar has some yellow paint on it. Independent suspension is any automobile suspension system that allows each wheel on the same axle to move vertically (i.e. reacting to a bump on the road) independently of the others. This is contrasted with a beam axle or deDion axle system in which the wheels are linked. "Independent" refers to ...
An active suspension is a type of automotive suspension that uses an onboard control system to control the vertical movement of the vehicle's wheels and axles relative to the chassis or vehicle frame, rather than the conventional passive suspension that relies solely on large springs to maintain static support and dampen the vertical wheel movements caused by the road surface.
George Caramagna, a mechanic working on the suspension system, suggested installing a stabilizer (anti-roll or "anti-sway") bar, but was overruled by GM management. [citation needed] To make up for the cost-cutting lack of a front stabilizer bar, Corvairs required tire pressures which were outside of the tire manufacturers' recommended tolerances.