Search results
Results From The WOW.Com Content Network
Schoolroom ventilation on the plenum system. The term "plenum" was coined in the 1670s, derived from Latin adjective plenus ("filled, full"). The usage originates from classical theories of physics and the notion that "nature abhors a vacuum". These gave rise to the notion of 17th century 'plenum' as the opposite of vacuum, and all things ...
The mix of fresh air and recirculated air can thus be adjusted to suit the needs of the building's occupants. Most systems will use motorized dampers to control the air mixing, and controlled by the building management system (BMS), or controls system. Typically as the fresh air and exhaust air dampers are driven from 0% open to 100% open, the ...
Gasoline is brought to the heater from the vehicle's fuel system. A fan blows air into a combustion chamber, where a glow plug or similar ignition device lights the gasoline/air mixture. Ducting around this contains a second fan, which blows air warmed by contact with the combustion chamber into the interior of the vehicle.
A register is a grille with moving parts, capable of being opened and closed and the air flow directed, which is part of a building's heating, ventilation, and air conditioning (HVAC) system. The placement and size of registers is critical to HVAC efficiency. Register dampers are also important, and can serve a safety function.
This damper can switch the electrical power to control additional "slave" dampers, minimizing the electrical load on the damper's control circuitry and power transformer. A zone damper (also known as a Volume Control Damper or VCD) is a specific type of damper used to control the flow of air in an HVAC heating or cooling system. In order to ...
A gas spring consists of a sealed cylinder filled with a charge of high-pressure [5] gas, a piston rod attached to a piston with a sliding seal, and some oil. [1] The piston (or the cylinder wall) contains a number of channels that allow the gas to transfer between the lower chamber (between the piston and the closed end of the cylinder) and the upper chamber (between the piston and the head ...
The combustion chamber in gas turbines and jet engines (including ramjets and scramjets) is called the combustor. The combustor is fed with high pressure air by the compression system, adds fuel and burns the mix and feeds the hot, high pressure exhaust into the turbine components of the engine or out the exhaust nozzle.
An industrial furnace, also known as a direct heater or a direct fired heater, is a device used to provide heat for an industrial process, typically higher than 400 degrees Celsius. [1] They are used to provide heat for a process or can serve as reactor which provides heats of reaction.