Search results
Results From The WOW.Com Content Network
The CBR test is a penetration test in which a standard piston, with a diameter of 50 mm (1.969 in), is used to penetrate the soil at a standard rate of 1.25 mm/minute. Although the force increases with the depth of penetration, in most cases, it does not increase as quickly as it does for the standard crushed rock, so the ratio decreases.
If the soil particles in a sample are predominantly in a relatively narrow range of sizes, the sample is uniformly graded. If a soil sample has distinct gaps in the gradation curve, e.g., a mixture of gravel and fine sand, with no coarse sand, the sample may be gap graded. Uniformly graded and gap graded soils are both considered to be poorly ...
Symbol used in drawings Standard penetration test N values from a surficial aquifer in south Florida. The standard penetration test (SPT) is an in-situ dynamic penetration test designed to provide information on the geotechnical engineering properties of soil. This test is the most frequently used subsurface exploration drilling test performed ...
The R-Value test [1] measures the response of a compacted sample of soil or aggregate to a vertically applied pressure under specific conditions. This test is used by Caltrans for pavement design, replacing the California bearing ratio test. Many other agencies have adopted the California pavement design method, and specify R-Value testing for ...
The bearing capacity of soil is the maximum average contact pressure between the foundation and the soil which should not produce shear failure in the soil. Ultimate bearing capacity is the theoretical maximum pressure which can be supported without failure; allowable bearing capacity is the ultimate bearing capacity divided by a factor of safety.
In this report the CBR-method (California Bearing Ratio) is primarily referred to. The so-called CBR-value represents the ratio of the percentage of the loads required to press a punch of certain dimensions first into a well compacted sample of soil and then into a standard sample of compacted gravels, to a depth of 0.1 inch.
The cone penetration or cone penetrometer test (CPT) is a method used to determine the geotechnical engineering properties of soils and delineating soil stratigraphy. It was initially developed in the 1950s at the Dutch Laboratory for Soil Mechanics in Delft to investigate soft soils. Based on this history it has also been called the "Dutch ...
AASHTO Soil Classification System (from AASHTO M 145 or ASTM D3282) General Classification Granular Materials (35% or less passing the 0.075 mm (No. 200) sieve) Silt-Clay Materials (>35% passing the 0.075 mm (No. 200) sieve) Group Classification A-1 A-3 A-2 A-4 A-5 A-6 A-7 A-1-a A-1-b A-2-4 A-2-5 A-2-6 A-2-7 A-7-5 A-7-6 Sieve Analysis, % passing