Ads
related to: 1 2 brass bulkhead fitting
Search results
Results From The WOW.Com Content Network
JIC fitting systems have three components that make a tubing assembly: fitting, flare nut, and sleeve. As with other flared connection systems, the seal is achieved through metal-to-metal contact between the finished surface of the fitting nose and the inside diameter of the flared tubing.
A compression fitting 15 mm isolating valve. A compression fitting is a fitting used in plumbing and electrical conduit systems to join two tubes or thin-walled pipes together. . In instances where two pipes made of dissimilar materials are to be joined (most commonly PVC and copper), the fittings will be made of one or more compatible materials appropriate for the connect
Tank connectors are a type of tank fitting also known as tank inlets, tank outlets, or tank nipples. This fitting must be leakage proof, as the water supply (inward and outward) depends on same. Many different varieties of tank connectors exist. Tank connectors are widely made of plastic or brass. They have a flange either on the edge of one ...
Cable glands may also be used for sealing cables passing through bulkheads [2] or gland plates. Cable glands are mostly used for cables with diameters between 1 mm and 75 mm. [3] Cable glands are commonly defined as mechanical cable entry devices. [4]
John Guest (Established in 1961, West Drayton, UK) developed the Speedfit push-fit connector for compressed air use in 1974, and introduced plumbing fittings in 1987. [2] These fittings are white plastic, and are unscrewable to replace components, like Hep2O, but also have a push-release mechanism. Speedfit uses plastic pipe support inserts.
Flared fittings are an alternative to solder-type joints that are mechanically separable and doesn’t require an open flame. Copper tube used for propane, liquefied petroleum gas, or natural gas may use flared brass fittings of single 45°-flare type, according to NFPA 54/ANSI. Z223.1 National Fuel Gas Code.