Search results
Results From The WOW.Com Content Network
Balanced, symmetrical circuit. A balanced circuit will normally show a symmetry of its components about a horizontal line midway between the two conductors (example in figure 3). This is different from what is normally meant by a symmetrical circuit, which is a circuit showing symmetry of its components about a vertical line at its midpoint. An ...
Such circuits are widely used for frequency conversion in radio systems. [1] The advantage of this circuit is the output current is an accurate multiplication of the (differential) base currents of both inputs. As a mixer, its balanced operation cancels out many unwanted mixing products, resulting in a "cleaner" output.
Active topologies also include active components (such as transistors, op amps, and other integrated circuits) that require power. Further, topologies may be implemented either in unbalanced form or else in balanced form when employed in balanced circuits. Implementations such as electronic mixers and stereo sound may require arrays of ...
These three components complete a full circuit for a signal to travel through and the impedances of this circuit is what determines whether the interface as a whole is balanced or not: [3] "A balanced circuit is a two-conductor circuit in which both conductors and all circuits connected to them have the same impedance to ground and to all other ...
A floorplan that consists of a single rectangular block is sliceable. If a block from a sliceable floorplan is cut ("sliced") in two by a vertical or horizontal line, the resulting floorplan is sliceable. Sliceable floorplans have been used in a number of early electronic design automation tools [1] for a number of reasons.
Schematic circuit of a Π-pad attenuator. The Π pad (pi pad) is a specific type of attenuator circuit in electronics whereby the topology of the circuit is formed in the shape of the Greek capital letter pi (Π). Attenuators are used in electronics to reduce the level of a signal.
Distributed-element circuits are designed with the distributed-element model, an alternative to the lumped-element model in which the passive electrical elements of electrical resistance, capacitance and inductance are assumed to be "lumped" at one point in space in a resistor, capacitor or inductor, respectively.
A partially balanced incomplete block design with n associate classes (PBIBD(n)) is a block design based on a v-set X with b blocks each of size k and with each element appearing in r blocks, such that there is an association scheme with n classes defined on X where, if elements x and y are ith associates, 1 ≤ i ≤ n, then they are together ...