When.com Web Search

  1. Ads

    related to: submersible pump calculation sheet printable

Search results

  1. Results From The WOW.Com Content Network
  2. Net positive suction head - Wikipedia

    en.wikipedia.org/wiki/Net_positive_suction_head

    If an NPSH A is say 10 bar then the pump you are using will deliver exactly 10 bar more over the entire operational curve of a pump than its listed operational curve. Example: A pump with a max. pressure head of 8 bar (80 metres) will actually run at 18 bar if the NPSH A is 10 bar. i.e.: 8 bar (pump curve) plus 10 bar NPSH A = 18 bar.

  3. Completion (oil and gas wells) - Wikipedia

    en.wikipedia.org/wiki/Completion_(oil_and_gas_wells)

    Pumping flow: the tubing and pump are run to a depth beneath the working fluid. The pump and rod string are installed concentrically within the tubing. A tubing anchor prevents tubing movement while pumping. Tubing flow: a tubing string and a production packer are installed. The packer means that all the flow goes through the tubing.

  4. Submersible pump - Wikipedia

    en.wikipedia.org/wiki/Submersible_pump

    A 0.75 HP bore-well submersible pump which had been used to pump groundwater One style of submersible pump for industrial use. Outlet pipe and electrical cable not connected. A submersible pump (or electric submersible pump (ESP) is a device which has a hermetically sealed motor close-coupled to the pump body. The whole assembly is submerged in ...

  5. Total dynamic head - Wikipedia

    en.wikipedia.org/wiki/Total_dynamic_head

    In fluid dynamics, total dynamic head (TDH) is the work to be done by a pump, per unit weight, per unit volume of fluid.TDH is the total amount of system pressure, measured in feet, where water can flow through a system before gravity takes over, and is essential for pump specification.

  6. Pressure tank - Wikipedia

    en.wikipedia.org/wiki/Pressure_tank

    A simple control system for a water well. Referring to the figure on the left, a submersible water pump is installed in a well.The pressure switch turns the water pump on when it senses a pressure that is less than P lo and turns it off when it senses a pressure greater than P hi.

  7. Pumping station - Wikipedia

    en.wikipedia.org/wiki/Pumping_station

    Submersible pumps are mounted on two vertical guide rails and seal onto a permanently fixed "duckfoot", which forms both a mount and also a vertical bend for the discharge pipe. For maintenance or replacement, submersible pumps are raised by a chain off of the duckfoot and up the two guide rails to the maintenance (normally ground) level.