Search results
Results From The WOW.Com Content Network
Twin-Traction Beam was invented by John A. Richardson and Donald G. Wheatley of Ford Motor Company covered by US patent 3,948,337 issued April 6, 1976. The patent name was “Independent front suspension for front-wheel drive” which was assigned to Ford Motor Company. [1] [2] The Dana Holding Corporation manufactured
The double-wishbone suspension can also be referred to as ‘double A-arm,’ though the arms themselves can be A-shaped, L-shaped, or even a single bar linkage. The complete TAK-4 independent suspension system set-up also includes a subframe which contains the axle differential, half shafts, and wheel ends with steering attachments and brakes.
Timoney Technology Limited of Ireland is an Irish company which designs, develops and manufactures powertrains and independent suspension systems for heavy duty trucks, motor coaches and military vehicles. Timoney designs and develops a variety of standard armoured and soft skin mobility systems for military, commercial and specialist ...
This is an example of a "dead axle". A "live axle" not only connects two wheels, but also drives them. A beam axle, rigid axle, or solid axle is a dependent suspension design in which a set of wheels is connected laterally by a single beam or shaft. Beam axles were once commonly used at the rear wheels of a vehicle, but historically, they have ...
Comparison between normal and portal axles Pinzgauer portal axle. A portal axle (or portal gear lift) is an off-road vehicle suspension and drive technology where the axle tube or the half-shaft is offset from – usually above – the center of the wheel hub and where driving power is transferred to each wheel via a simple gearbox, built onto each hub. [1]
The axles had u-joints to allow for the independent action of the beams. Individual pivot points for the beams at greater than center made each beam longer than half the overall width crossing in the middle. This allowed for an independent front suspension design. Ford TTB Dana 44 axles all utilized locking hubs. The TTB set-up is based on Ford ...
Most eight-wheel drive trucks have two front and two rear axles, with only the front pair steering. Occasionally a single front and three rear (tridem) axles are seen, an example being the Oshkosh M1070 tank transporter. In such configurations, the frontmost and rearmost axle usually steer. [3] Other wheel groupings include that of the ZIL-135.
Anti-roll bar (in red) attached to a front axle. The bar must also have its two longitudinal anchor points fastened solidly to transfer forces from side to side. An anti-sway or anti-roll bar is intended to reduce the lateral tilt (roll) of the vehicle on curves, sharp corners, or large bumps.