Search results
Results From The WOW.Com Content Network
Use of the kilogram-force per square centimetre continues primarily due to older pressure measurement devices still in use. This use of the unit of pressure provides an intuitive understanding for how a body's mass, in contexts with roughly standard gravity, can apply force to a scale's surface area, i.e. kilogram-force per square (centi-)metre.
The Vickers hardness test was developed in 1921 by Robert L. Smith and George E. Sandland at Vickers Ltd as an alternative to the Brinell method to measure the hardness of materials. [1] The Vickers test is often easier to use than other hardness tests since the required calculations are independent of the size of the indenter, and the indenter ...
where: L is the length of indentation along its long axis C p is the correction factor related to the shape of the indenter, ideally 0.070279 P is the load. HK values are typically in the range from 100 to 1000, when specified in the conventional units of kg f ⋅mm −2.
Converts measurements to other units. Template parameters [Edit template data] This template prefers inline formatting of parameters. Parameter Description Type Status Value 1 The value to convert. Number required From unit 2 The unit for the provided value. Suggested values km2 m2 cm2 mm2 ha sqmi acre sqyd sqft sqin km m cm mm mi yd ft in kg g mg lb oz m/s km/h mph K C F m3 cm3 mm3 L mL cuft ...
Nm kg.m; Nm lb.ft; Non-SI metric: kilogram metre: kg.m kg⋅m 1.0 kg⋅m (9.8 N⋅m; 7.2 lb⋅ft) kg.m Nm; kg.m lb.ft; Imperial & US customary: pound force-foot: lb.ft lb⋅ft 1.0 lb⋅ft (1.4 N⋅m) lb.ft Nm; lb.ft kg-m; Scientific: SI: newton-metre: N.m N⋅m Triple combinations are also possible. See the full list. 1.0 N⋅m (0.74 lbf⋅ft ...
The hyl is a unit of mass equal to 1 kgf⋅m −1 ⋅s 2 (9.806 65 kg). The poncelet (p) is a unit of power equal to 1 kgf ⋅m⋅s −1 ( 980.665 W ). The technical atmosphere (at) is a (non-coherent) unit of pressure equal to 1 kgf ⋅cm −2 ( 98 066 .5 Pa ).
0.1 mPa is the lowest direct measurement of pressure that is possible with current technology. Other vacuum gauges can measure lower pressures, but only indirectly by measurement of other pressure-dependent properties. These indirect measurements must be calibrated to SI units by a direct measurement, most commonly a McLeod gauge. [22]
The equation based definition of hardness is the pressure applied over the contact area between the indenter and the material being tested. As a result hardness values are typically reported in units of pressure, although this is only a "true" pressure if the indenter and surface interface is perfectly flat. [citation needed]