Ads
related to: internal pvc cutter 1 inch hose adapter female to male enlarger video
Search results
Results From The WOW.Com Content Network
Schematic symbols for male and female connector pins. In electrical and mechanical trades and manufacturing, each half of a pair of mating connectors or fasteners is conventionally designated as male or female, [1] a distinction referred to as its gender. [2] The female connector is generally a receptacle that receives and holds the male connector.
Piping or tubing is usually inserted into fittings to make connections. Connectors are assigned a gender, abbreviated M or F. An example of this is a "3 ⁄ 4-inch female adapter NPT", which would have a corresponding male connection of the same size and thread standard (in this case also NPT).
JIC hydraulic fitting from 1967 Ford backhoe. It was badly stuck, but shows what a JIC fitting looks like. The left is the male part, the right is female. A JIC bulkhead adapter, which converts National Pipe Thread (NPT) on the left to JIC on the right. The angled seating surface is clearly visible on the far right.
These sizing schemes allow for universal adaptation of transitional fittings. For instance, 1/2" PeX tubing is the same size as 1/2" copper tubing. 1/2" PVC on the other hand is not the same size as 1/2" tubing, and therefore requires either a threaded male or female adapter to connect them.
Hose handling system, for both hydraulic and slurry hoses; these systems can use either a hose drum or a hose tension design Hydraulic cutter, which typically consists of two cutter wheels powered by a hydraulic motor , a slurry pump , and flaps to control its direction in case of deviation from the intended path.
Consequently, a 1-inch (25 mm) copper pipe had a 1 + 1 ⁄ 8-inch (28.58 mm) outside diameter. The outside diameter was the important dimension for mating with fittings. The wall thickness on modern copper is usually thinner than 1 ⁄ 16-inch (1.6 mm), so the internal diameter is only "nominal" rather than a controlling dimension. [13]