Search results
Results From The WOW.Com Content Network
Engine crankcase pressure sensor; Exhaust gas temperature sensor; Fuel level sensor; Fuel pressure sensor; Knock sensor; Light sensor; MAP sensor; Mass airflow sensor; Oil level sensor; Oil pressure sensor; Omniview technology; Oxygen sensor (O 2) Parking sensor; Radar gun; Radar sensor; Speed sensor; Throttle position sensor; Tire pressure ...
A piezoelectric sensor is a device that uses the piezoelectric effect to measure changes in pressure, acceleration, temperature, strain, or force by converting them to an electrical charge. The prefix piezo- is Greek for 'press' or 'squeeze'.
Actuator Sensor Interface (AS-Interface or ASi) is an industrial networking solution (Physical Layer, Data access Method and Protocol) used in PLC, DCS and PC-based automation systems. It is designed for connecting simple field I/O devices (e.g. binary ON/OFF devices such as actuators, sensors, rotary encoders, analog inputs and outputs, push ...
Arduino layout-compatible board, designed for use with a USB-TTL serial cable. DuinoBot v1.x [89] ATmega32U4 RobotGroup Argentina [90] Arduino fully compatible board, with integrated power supply and controllers designed for robotics. Compatible as well with the system "Multiplo" eJackino [91] Kit by CQ publisher in Japan.
Arduino (/ ɑː r ˈ d w iː n oʊ /) is an Italian open-source hardware and software company, project, and user community that designs and manufactures single-board microcontrollers and microcontroller kits for building digital devices.
The squeeze-film pressure sensor is a type of MEMS resonant pressure sensor that operates by a thin membrane that compresses a thin film of gas at high frequency. Since the compressibility and stiffness of the gas film are pressure dependent, the resonance frequency of the squeeze-film pressure sensor is used as a measure of the gas pressure.
Arduino layout-compatible board, designed for use with a USB-TTL serial cable. DuinoBot v1.x [79] RobotGroup Argentina [80] ATmega32U4 16 MHz Arduino fully compatible board, with integrated power supply and controllers designed for robotics. Compatible as well with the system "Multiplo" eJackino [81] Kit by CQ publisher in Japan.
A typical nominal regulated gauge pressure from a medical oxygen regulator is 3.4 bars (50 psi), for an absolute pressure of approximately 4.4 bar and a pressure ratio of about 4.4 without back pressure, so they will have choked flow in the metering orifices for a downstream (outlet) pressure of up to about 2.3 bar absolute.