Search results
Results From The WOW.Com Content Network
Reverse side of the same 402 plugboard, showing the pins that make contact with the machine's internal wiring. The holes were called hubs. A plugboard or control panel (the term used depends on the application area) is an array of jacks or sockets (often called hubs) into which patch cords can be inserted to complete an electrical circuit.
IEC 60417-5008, [7] the power-off symbol (circle) on a button or toggle, indicates that using the control will disconnect power to the device. (0 or means off.) IEC 60417-5009, [8] the standby symbol (line partially within a broken circle), indicates a sleep mode or low power state. The switch does not fully disconnect the device from its power ...
Wire crossover symbols for circuit diagrams. The CAD symbol for insulated crossing wires is the same as the older, non-CAD symbol for non-insulated crossing wires. To avoid confusion, the wire "jump" (semi-circle) symbol for insulated wires in non-CAD schematics is recommended (as opposed to using the CAD-style symbol for no connection), so as to avoid confusion with the original, older style ...
In 1944, the Luftwaffe introduced a plugboard switch, called the Uhr (clock), a small box containing a switch with 40 positions. It replaced the standard plugs. After connecting the plugs, as determined in the daily key sheet, the operator turned the switch into one of the 40 positions, each producing a different combination of plug wiring.
Overall the K2 switch panel switches and the plugboard allowed about five billion different combinations of the selected variables. [ 61 ] As an example: a set of runs for a message tape might initially involve two chi wheels, as in Tutte's 1+2 algorithm.
A less common symbol is simply a series of peaks on one side of the line representing the conductor, rather than back-and-forth. Wire crossover symbols for circuit diagrams. The CAD symbol for insulated crossing wires is the same as the older, non-CAD symbol for non-insulated crossing wires. To avoid confusion, the wire "jump" (semi-circle ...
A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board.The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15.
A second application was a transistorized digital computer to be used in a Navy track-while-scan shipboard radar system. Several models were completed: TRADIC Phase One computer, Flyable TRADIC, Leprechaun (using germanium alloy junction transistors in 1956) and XMH-3 TRADIC. TRADIC Phase One was developed to explore the feasibility, in the ...