Ads
related to: oil piston airbrush compressor
Search results
Results From The WOW.Com Content Network
A reciprocating compressor or piston compressor is a positive-displacement compressor that uses pistons driven by a crankshaft to deliver gases at high pressure. [ 1 ] [ 2 ] Pressures of up to 5,000 psig are commonly produced by multistage reciprocating compressors.
In electric diaphragm pumps, the motor drives a hydraulic piston pump that transmits the oil displaced by the piston, to move the diaphragm. Hydraulic and air-powered airless pumps have linear motors that require a hydraulic pump or an air compressor, which can be electric or gasoline-powered, although an air compressor is usually diesel ...
The built-in oil pump is connected to the same shaft that drives the compressor, and forces oil into the compressor and motor bearings. At low speeds, insufficient quantities of oil reach the bearings, eventually leading to bearing failure, while at high speeds, excessive amounts of oil may be lost from the bearings and compressor and ...
Consequently, air treatment identical to that used for an oil-flooded screw compressor is frequently required to ensure quality compressed air. In small piston compressors carpenters homeowners sometimes use "oil free" compressors in which oil free is a reference to not using oil but Teflon type of coatings permanently adhered to wear surfaces.
Free-piston engine used as a gas generator to drive a turbine. A free-piston engine is a linear, 'crankless' internal combustion engine, in which the piston motion is not controlled by a crankshaft but determined by the interaction of forces from the combustion chamber gases, a rebound device (e.g., a piston in a closed cylinder) and a load device (e.g. a gas compressor or a linear alternator).
Typical horizontal steam engine with double-acting cylinder. A double-acting cylinder is a cylinder in which the working fluid acts alternately on both sides of the piston. . In order to connect the piston in a double-acting cylinder to an external mechanism, such as a crank shaft, a hole must be provided in one end of the cylinder for the piston rod, and this is fitted with a gland or ...