When.com Web Search

  1. Ads

    related to: function of proximity switch sensor npn circuit board

Search results

  1. Results From The WOW.Com Content Network
  2. Proximity sensor - Wikipedia

    en.wikipedia.org/wiki/Proximity_sensor

    The sensor itself is the black object on top of the yellow block below it; this block is actually a printed circuit board serving as an interposer. A proximity sensor (often simply prox ) is a sensor able to detect the presence of nearby objects without any physical contact.

  3. Inductive sensor - Wikipedia

    en.wikipedia.org/wiki/Inductive_sensor

    Since the output of an inductive sensor has two possible states, an inductive sensor is sometimes referred to as an inductive proximity switch. [2] [3] The sensor consists of an induction loop or detector coil. Most often this is physically a number of turns of insulated magnet wire wound around a high magnetic permeability core, such as a ...

  4. Open collector - Wikipedia

    en.wikipedia.org/wiki/Open_collector

    For NPN open collector outputs, the emitter of the NPN transistor is internally connected to ground, [1] so the NPN open collector internally forms either a short-circuit (technically low impedance or "low-Z") connection to the low voltage (which could be ground) when the transistor is switched on, or an open-circuit (technically high impedance ...

  5. Photoelectric sensor - Wikipedia

    en.wikipedia.org/wiki/Photoelectric_sensor

    Remote photoelectric sensors used for remote sensing contain only the optical components of a sensor. The circuitry for power input, amplification, and output switching is located elsewhere, typically in a control panel. This allows the sensor, itself, to be very small. Also, the controls for the sensor are more accessible, since they may be ...

  6. Hall effect sensor - Wikipedia

    en.wikipedia.org/wiki/Hall_effect_sensor

    Hall effect devices produce a very low signal level and thus require amplification. The vacuum tube amplifier technology available in the first half of the 20th century was too large, expensive, and power-consuming for everyday Hall effect sensor applications, which were limited to laboratory instruments.

  7. Reference designator - Wikipedia

    en.wikipedia.org/wiki/Reference_designator

    A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board.The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15.