Search results
Results From The WOW.Com Content Network
Gargoyle is a free OpenWrt-based Linux distribution for a range of wireless routers based on Broadcom, Atheros, MediaTek and others chipsets, [2] [3] Asus Routers, Netgear, Linksys and TP-Link routers. Among notable features is the ability to limit and monitor bandwidth and set bandwidth caps per specific IP address. [4] [5] [6] [7]
6in4, sometimes referred to as SIT, [a] is an IPv6 transition mechanism for migrating from Internet Protocol version 4 (IPv4) to IPv6. It is a tunneling protocol that encapsulates IPv6 packets on specially configured IPv4 links according to the specifications of RFC 4213. The IP protocol number for 6in4 is 41, per IANA reservation. [1]
OpenWrt provides exhaustive possibilities to configure common network-related features, like IPv4, IPv6, DNS, DHCP, routing, firewall, NAT, port forwarding and WPA. Other features include: Extensible configuration of the entire hardware drivers, e.g. built-in network switches and their VLAN -capabilities, WNICs , DSL modems , FX , available ...
The Dynamic Host Configuration Protocol version 6 (DHCPv6) is a network protocol for configuring Internet Protocol version 6 (IPv6) hosts with IP addresses, IP prefixes, default route, local segment MTU, and other configuration data required to operate in an IPv6 network.
A wireless configuration utility, [1] wireless configuration tool, [1] wireless LAN client, [citation needed] or wireless connection management utility [citation needed] is a class of network management software that manages the activities and features of a wireless network connection.
There is a difference between a "relay router" and a "border router" (also known as a "6to4 border router"). A 6to4 border router is an IPv6 router supporting a 6to4 pseudo-interface. It is normally the border router between an IPv6 site and a wide-area IPv4 network, where the IPv6 site uses 2002:: / 16 co-related to the IPv4 address used later ...
4in6 refers to tunneling of IPv4 in IPv6. [1] [2] It is an Internet interoperation mechanism allowing Internet Protocol version 4 (IPv4) to be used in an IPv6 only network. 4in6 uses tunneling to encapsulate IPv4 traffic over configured IPv6 tunnels as defined in RFC 2473.
For IPv6, Path MTU Discovery works by initially assuming the path MTU is the same as the MTU on the link layer interface where the traffic originates. Then, similar to IPv4, any device along the path whose MTU is smaller than the packet will drop the packet and send back an ICMPv6 Packet Too Big (Type 2) message containing its MTU, allowing the ...