When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Attic fan - Wikipedia

   en.wikipedia.org/wiki/Attic_fan

   A fan may be installed in an attic for the different purpose of cooling a whole house, venting hot air out via the attic; such fans are often called whole-house fans. Wind-powered roof turbine ventilator. Mechanical attic ventilation fans may be powered in a variety of different ways. Most attic ventilators fitted to homes are powered off mains ...

3. Whole-house fan - Wikipedia

   en.wikipedia.org/wiki/Whole-house_fan

   A whole house fan pulls air out of a building and forces it into the attic space or, in the case of homes without attics, through an opening in the roof or an outside wall. This forces air from the living areas into the attic and out through the gable and/or soffit vents, while at the same time drawing air from the outside into the living areas ...

4. 50 Times Cheap Fixes Had A Major Impact On Home Life - AOL

   www.aol.com/55-people-share-relatively-cheap...

   The only lighting my house had was from ceiling fans so most of the rooms were way too dark. Adding 4 recessed lights on a dimmer switch is under $200/room and is such a quality of life ...

5. Thermal destratification - Wikipedia

   en.wikipedia.org/wiki/Thermal_destratification

   Because axial fans are designed to blow air straight down at the floor, they can be used in ceiling and roof structures over 100 ft. tall. Because axial destratification fans can achieve destratification with low CFMs, it is imperative that the air leaving the nozzle achieve an air speed at the floor of between 0.2 and 0.5 m/s.

6. Passive ventilation - Wikipedia

   en.wikipedia.org/wiki/Passive_ventilation

   Both supply and exhaust happened through an unconditioned attic space, with exhaust air being extracted at ceiling height and air being supplied at floor level through a vertical duct. The device was found to provide sufficient ventilation air flow for a single family home and heat recovery with an efficiency around 40%.

7. DI-WHY? 5 Home DIY Fails That Scream "Call a Pro" - AOL

   www.aol.com/di-why-5-home-diy-140000179.html

   The flat metal bars you see are normally used to install heaters, panels and ductwork, not to replace a ceiling fan box! One can only imagine the sound it makes when turned on. Scary!