Search results
Results From The WOW.Com Content Network
Chain tensioner on a single-speed bicycle Belt tensioner on a belt-drive bicycle Hydraulic bolt tensioner Hydraulic Puller-tensioner . A tensioner is a device that applies a force to create or maintain tension. The force may be applied parallel to, as in the case of a hydraulic bolt tensioner, or perpendicular to, as in the case of a spring ...
This page was last edited on 30 January 2012, at 22:03 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may apply.
Nine men pull on a rope. The rope in the photo extends into a drawn illustration showing adjacent segments of the rope. One segment is duplicated in a free body diagram showing a pair of action-reaction forces of magnitude T pulling the segment in opposite directions, where T is transmitted axially and is called the tension force.
Multi-jackbolt tensioners (MJTs), registered under the trademark Superbolt or Supernut, are designed to decrease the torque required to tighten large bolted joints. One of the major problems associated with traditional bolt tightening methods is as the diameter of the bolt increases, the amount of torque required to tighten it increases in the third power of the diameter. [1]
Small (80 mm (3 + 5 ⁄ 32 in)) turnbuckleA turnbuckle, stretching screw or bottlescrew is a device for adjusting the tension or length of ropes, cables, tie rods, and other tensioning systems.
The mechanical belt drive, using a pulley machine, was first mentioned in the text of the Dictionary of Local Expressions by the Han Dynasty philosopher, poet, and politician Yang Xiong (53–18 BC) in 15 BC, used for a quilling machine that wound silk fibres onto bobbins for weavers' shuttles. [1]
Oil circulation system Gerotor type oil pump from a scooter engine. The oil pump is an internal combustion engine part that circulates engine oil under pressure to the rotating bearings, the sliding pistons and the camshaft of the engine.
The marine riser is connected to the wellhead on the sea bed and therefore the tensioner must manage the differential movements between the riser and the rig. If there were no tensioner and the rig moves downward, the riser would buckle; if the rig rises then high forces would be transmitted to the riser and it would stretch and be damaged.