When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. ISO standards for trailer connectors - Wikipedia

   en.wikipedia.org/wiki/ISO_standards_for_trailer...

   12 Volt 7-pin trailer connector ISO 7638-2 for ABS and EBS (Towing vehicle side) Physical design according to standard ISO 7638-2. [4] [6] [7] This connector is intended to be used for 12V ABS and EBS on heavy duty trailers. Identified by key tab on outer ring between pin 3 and 4. #

3. Anderson Powerpole - Wikipedia

   en.wikipedia.org/wiki/Anderson_Powerpole

   Many pieces of amateur radio equipment run on 12-volt DC automotive voltage, which is also called 13.8-volt DC. The voltage delivered by a lead–acid battery with six-cells used as an automotive battery will vary depending on various electrical loads in a vehicle. Without loads the battery will float from 11.7 to 12.8 volts, and while charging ...

4. Power Wheels - Wikipedia

   en.wikipedia.org/wiki/Power_Wheels

   In 1998, Fisher-Price undertook a monumental recall of up to 10 million Power Wheels 12 volt and Super 6 volt vehicles manufactured since 1986. [citation needed] The recall and repair program was conducted to replace battery fuses and strengthen battery connectors in order to prevent the units from overheating. The main difference of a post ...

5. Dodge Caravan - Wikipedia

   en.wikipedia.org/wiki/Dodge_Caravan

   In 1999, Dodge introduced the Caravan EPIC, a fully electric minivan. The EPIC was powered by 28 12-volt NiMH batteries and was capable of traveling up to 80 miles (130 km) on a single charge. The EPIC was a fleet-only lease vehicle. Production of the EPIC was discontinued in 2001. Only a few hundred of these vehicles were produced. [21]

6. SAE J1772 - Wikipedia

   en.wikipedia.org/wiki/SAE_J1772

   SAE J1772, also known as a J plug or Type 1 connector after its international standard, IEC 62196 Type 1, is a North American standard for electrical connectors for electric vehicles maintained by SAE International under the formal title "SAE Surface Vehicle Recommended Practice J1772, SAE Electric Vehicle Conductive Charge Coupler".

7. DC connector - Wikipedia

   en.wikipedia.org/wiki/DC_connector

   The polarity for 12 V DC sockets is center pin positive (+), outer collar negative (−). Reversed polarity will damage some electronic devices. Although the nominal voltage of a 12 V lead acid battery is 12 V DC, when the engine is running the car's battery charging system will bring the system voltage to 13.8 V DC or higher. [10]