Ad
related to: 10k ntc thermistor chart printable images full size
Search results
Results From The WOW.Com Content Network
The integrated circuit sensor may come in a variety of interfaces — analogue or digital; for digital, these could be Serial Peripheral Interface, SMBus/I 2 C or 1-Wire.. In OpenBSD, many of the I 2 C temperature sensors from the below list have been supported and are accessible through the generalised hardware sensors framework [3] since OpenBSD 3.9 (2006), [4] [5]: §6.1 which has also ...
The resulting voltage drop from the operating resistance and the power consumption of the thermistor must be taken into account. Inrush current limiting thermistors are usually disk-shaped, with a radial lead on each side. NTC resistor power handling is proportional to its size. NTC resistors are rated according to their resistance at room ...
NTC thermistors are widely used as inrush-current limiters and temperature sensors, while PTC thermistors are used as self-resetting overcurrent protectors and self-regulating heating elements. An operational temperature range of a thermistor is dependent on the probe type and is typically between −100 and 300 °C (−148 and 572 °F).
Original file (SVG file, nominally 45 × 32 pixels, file size: 1 KB) This is a file from the Wikimedia Commons . Information from its description page there is shown below.
Size A standard RTD sheath is 3.175 to 6.35 mm (0.1250 to 0.2500 in) in diameter; sheath diameters for thermocouples can be less than 1.6 mm (0.063 in). Accuracy and stability requirements If a tolerance of 2 °C is acceptable and the highest level of repeatability is not required, a thermocouple will serve.
With the PC industry rising from the 1980s in Taiwan, its NTC thermistor is adapted as the inrush current limiter in switched-mode power supply to suppress the inrush current when power supply turns on, and the varistor protects the circuit from damaged by surge current occasionally occurred in the electricity network.
The lower the coefficient, the greater a decrease in electrical resistance for a given temperature increase. NTC materials are used to create inrush current limiters (because they present higher initial resistance until the current limiter reaches quiescent temperature), temperature sensors and thermistors.
Steinhart–Hart coefficients for specific commercial devices are ordinarily reported by thermistor manufacturers as part of the device characteristics. Finding characteristics from measurements of resistance at known temperatures