Search results
Results From The WOW.Com Content Network
Thus alerting all nodes within range of the sender, receiver or both, to not transmit for the duration of the main transmission. This is known as the IEEE 802.11 RTS/CTS exchange. Implementation of RTS/CTS helps to partially solve the hidden node problem that is often found in wireless networking. [10] [11]
Source: [1] Node D is unaware of the ongoing data transfer between node A and node B. Node D has data to send to node C, which is in the transmission range of node B. D initiates the process by sending an RTS frame to node C. Node C has already deferred its transmission until the completion of the current data transfer between node A and node B (to avoid co-channel interference at node B).
The same problem exists in a mobile ad hoc network . IEEE 802.11 uses 802.11 RTS/CTS acknowledgment and handshake packets to partly overcome the hidden node problem. RTS/CTS is not a complete solution and may decrease throughput even further, but adaptive acknowledgements from the base station can help too.
IEEE 802.11 RTS/CTS (request to send/clear to send) is the optional mechanism used by the 802.11 wireless networking protocol to reduce frame collisions introduced by the hidden node problem. Originally the protocol fixed the exposed node problem as well, but later RTS/CTS does not, but includes ACKs.
Unlike the original use of RTS and CTS with half-duplex modems, these two signals operate independently from one another. This is an example of hardware flow control. However, "hardware flow control" in the description of the options available on an RS-232-equipped device does not always mean RTS/CTS handshaking.
IEEE 802.11 RTS/CTS mechanism helps to solve this problem only if the nodes are synchronized and packet sizes and data rates are the same for both the transmitting nodes. When a node hears an RTS from a neighboring node, but not the corresponding CTS, that node can deduce that it is an exposed node and is permitted to transmit to other ...
If the receiver allows the transmission, it replies the sender a signal called Clear-To-Send (CTS) with the length of the frame that is about to receive. Meanwhile, a node that hears RTS should remain silent to avoid conflict with CTS; a node that hears CTS should keep silent until the data transmission is complete.
RTS/CTS (request to send/ clear to send) may refer to: Request to send and clear to send, flow control signals RS-232 RTS/CTS, today's [as of?] ...