Ads
related to: how to make a hot wire foam cutter power supply
Search results
Results From The WOW.Com Content Network
Hot-wiring, a method of starting a car with no key; Hot-wire foam cutter, a tool used to cut foam and polystyrene; Hot wire (electricity), a wire conductor with non-zero potential in electric power distribution; Hot-wire anemometer, an electrical device for measuring the speed of airflow
The failure of a neutral fuse would cut off power flow through the affected circuit, but the hot conductor could still remain hot relative to ground, an unexpected and potentially hazardous situation. Because of the presence of a neutral fuse, and in the event that it blew, the neutral conductor could not be relied on to remain near ground ...
The upper and lower diamond guides are usually accurate to 0.004 mm (0.16 mils), and can have a cutting path or kerf as small as 0.021 mm (0.83 mils) using Ø 0.02 mm (0.79 mils) wire, though the average cutting kerf that achieves the best economic cost and machining time is 0.335 mm (13.2 mils) using Ø 0.25 mm (9.8 mils) brass wire.
A worker may use a conducting wand during the approach to first make the connection. Once on the line, the worker is safe from shock as both the lineworker and the wire are at the same electric potential, and hence no current passes through their body. This is the same principle as that which allows birds to safely sit on power lines. [3]
First, a pattern is made from polystyrene foam, which can be done by many different ways.For small volume runs the pattern can be hand cut or machined from a solid block of foam, or a sheet of foam core board if the geometry is simple enough it can even be cut using a hot-wire foam cutter.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!