Ads
related to: ball swivel connector for refrigerator lock system
Search results
Results From The WOW.Com Content Network
Male threaded Heim Joint (A) the casing (B) the ball swivel (C) the opening for attaching hardware (D) the threaded shaft. A rod end bearing, also known as a heim joint (N. America) or rose joint (U.K. and elsewhere), is a mechanical articulating joint.
Ball chain detail Dogtags on ball chain. Ball chain or bead chain is a type of chain consisting of small sheet metal balls connected via short lengths of wire. [1] The balls are hollow and have two small antipodal holes. These holes accept a short length of wire deformed on the end like a rivet so that the end is bound inside the ball. The wire ...
When a boat swings on a well-embedded anchor, this can cause strong lateral loads on the swivel, causing its jaws to be pried open - thus disconnecting the chain from the swivel. Hence the above advice from Rocna. [4] Some boating schools teach that the anchor should be pulled tight against the bow roller by the windlass.
A knuckle joint on a locomotive, seen behind the pin joint of the eccentric crank. Ball-point pen included for size. A mechanical joint is a section of a machine which is used to connect one or more mechanical parts to another. Mechanical joints may be temporary or permanent; most types are designed to be disassembled.
The keyhole of a mechanical cam lock is usually the same as an ordinary padlock. A physical key is used to unlock the lock. The physical key has a notch or slot corresponding to the obstacle in the cam lock, allowing it to rotate freely in the lock. Different from mechanical cam locks, electronic cam locks use an electronic key to unlock.
The second most important part of the rotary union is the bearing. A rotary union may have only one bearing, but multiple bearing are much more common. Roller bearings; such as ball bearings and tapered roller bearings; or non-roller bearings, like graphite bearings and bronze bushings, may be used in a rotary union.
The locking coupling makes for a more reliable connection in commercial and industrial settings, where vibration or incidental impact could disconnect a non-locking connector. Locking connectors come in a variety of standardized configurations that follow the same general naming scheme except that the designations include an "L" for "locking".
The term is most often used in items like lockers, where it is contrasted with the much more secure three-point locking, which uses movable rods to secure the top and bottom of the door when the door is locked, and the term is not normally used in situations where single-point locking is the only option normally found.