When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Release agent - Wikipedia

   en.wikipedia.org/wiki/Release_agent

   The silicone keeps the rubber from sticking to the mold but just as important it lubricates the rubber so it will slide over the hot mold as it is loaded. Diluted silicone typically has to be applied every cycle. Semi-permanent mold release builds a silicone matrix on the mold that becomes a barrier between the rubber and the metal surface of ...

3. Vacuum casting (elastomers) - Wikipedia

   en.wikipedia.org/wiki/Vacuum_casting_(elastomers)

   The process starts by placing a two piece silicone mold in a vacuum chamber. The raw material is mixed, degassed and then poured into the mold. The vacuum is then released and the mold removed from the chamber. Finally, the casting is cured in an oven and the mold removed to release the completed casting. The silicone mold can be reused. [3]

4. Polydimethylsiloxane - Wikipedia

   en.wikipedia.org/wiki/Polydimethylsiloxane

   The rubbery, vinegary-smelling silicone caulks, adhesives, and aquarium sealants are also well-known. PDMS is also used as a component in silicone grease and other silicone based lubricants, as well as in defoaming agents, mold release agents, damping fluids, heat transfer fluids, polishes, cosmetics, hair conditioners and other applications.

5. Silicone - Wikipedia

   en.wikipedia.org/wiki/Silicone

   Two-part silicone systems are used as rubber molds to cast resins, foams, rubber, and low-temperature alloys. A silicone mold generally requires little or no mold-release or surface preparation, as most materials do not adhere to silicone. For experimental uses, ordinary one-part silicone can be used to make molds or to mold into shapes.

6. Injection molding of liquid silicone rubber - Wikipedia

   en.wikipedia.org/wiki/Injection_molding_of...

   Injection molding of liquid silicone rubber (LSR) is a process to produce pliable, durable parts in high volume.. Liquid silicone rubber is a high purity platinum cured silicone with low compression set, good stability and ability to resist extreme temperatures of heat and cold ideally suitable for production of parts, where high quality is required.

7. Potting (electronics) - Wikipedia

   en.wikipedia.org/wiki/Potting_(electronics)

   The mold may be part of the finished article and may provide shielding or heat dissipating functions in addition to acting as a mold. When the mold is removed the potted assembly is described as cast. [4] As an alternative, many circuit board assembly houses coat assemblies with a layer of transparent conformal coating rather than potting. [5]