Search results
Results From The WOW.Com Content Network
The lumen (symbol: lm) is the unit of luminous flux, a measure of the perceived power of visible light emitted by a source, in the International System of Units (SI). Luminous flux differs from power ( radiant flux ), which encompasses all electromagnetic waves emitted, including non-visible ones such as thermal radiation ( infrared ).
I e is the radiant intensity in watts per steradian (W/sr), y ¯ ( λ ) {\textstyle {\overline {y}}(\lambda )} is the standard luminosity function . If more than one wavelength is present (as is usually the case), one must sum or integrate over the spectrum of wavelengths present to get the luminous intensity:
Luminous flux (in lumens) is a measure of the total amount of light a lamp puts out. The luminous intensity (in candelas) is a measure of how bright the beam in a particular direction is. If a lamp has a 1 lumen bulb and the optics of the lamp are set up to focus the light evenly into a 1 steradian beam, then the beam would have a luminous ...
Therefore, the absolute magnitude can be calculated from a luminosity in watts: = + where L 0 is the zero point luminosity 3.0128 × 10 28 W and the luminosity in watts can be calculated from an absolute magnitude (although absolute magnitudes are often not measured relative to an absolute flux): L ∗ = L 0 × 10 − 0.4 M b o l ...
Luminous efficacy can be normalized by the maximum possible luminous efficacy to a dimensionless quantity called luminous efficiency.The distinction between efficacy and efficiency is not always carefully maintained in published sources, so it is not uncommon to see "efficiencies" expressed in lumens per watt, or "efficacies" expressed as a percentage.
Φ v is the luminous flux, in lumens; Φ e,λ is the spectral radiant flux, in watts per nanometre; y (λ), also known as V(λ), is the luminosity function, dimensionless; λ is the wavelength, in nanometres. Formally, the integral is the inner product of the luminosity function with the spectral power distribution. [2]
Halogen lamps made for 12 to 24 volt operation have good light outputs, and the very compact filaments are particularly beneficial for optical control (see picture). The ranges of multifaceted reflector "MR" lamps of 20–50 watts were originally conceived for the projection of 8 mm film, but are now widely used for display lighting and in the ...
An electronic amplifier that delivers 10 watts of power to its load (e.g., a loudspeaker), while drawing 20 watts of power from a power source is 50% efficient. (10/20 × 100 = 50%) Electric kettle: more than 90% [citation needed] (comparatively little heat energy is lost during the 2 to 3 minutes a kettle takes to boil water).