Search results
Results From The WOW.Com Content Network
Starting in 1973, AMC discontinued the use of the adapter ring, as it sourced a TH400 case from GM with the AMC bellhousing pattern already cast. The TH400 AMC case was used until the end of 1979 model production. The 232 cu in (3.8 L) I6 used in 1970-72 Jeep DJ "Postal Jeep" was backed up by the Borg-Warner T-35 3-speed automatic.
Manual – the driver has to perform each gear change using a manually operated clutch; Automatic – once placed in drive (or any other 'automatic' selector position), it automatically selects the gear ratio dependent on engine speed and load; Basically there are two types of engine installation:
The transmission has a 7.05:1 ratio first gear, which is one of the lowest "granny" gears ever produced in a production transmission. It weighs 135lb, which is 40 pounds less than the SM465 that replaced it. While the construction is dated by modern standards, these are sought after by off-road enthusiasts due to the ruggedness and gear ratios. [1]
1968 Camaro RS 327 (original optional stripe was black) 1968 Chevrolet Camaro SS convertible. The styling of the 1968 Camaro was very similar to the 1967 design. With the introduction of Astro Ventilation, a fresh-air-inlet system, the side vent windows were deleted. Side marker lights were added on the front and rear fenders as part of safety ...
The topic of available gear ratios has been widely debated due to the numerous applications of this transaxle. The 1987 GM Getrag Service Manual [1] confirms that there are at least two versions of the Getrag 282. According to the manual, the two versions were sold under 5 different part numbers based on body and engine usage.
Back in 1968, someone knew exactly what they wanted when they special ordered this Camaro with a bevy of options and a Corvette paint job. Numbers Matching, Fully Loaded: 1968 Chevrolet Camaro RS ...
Starter ring gear attached to a flywheel. In cars with a manual transmission, the starter ring gear is fitted to the outer diameter of the flywheel.The ring gear is usually fixed to the flywheel through use of an interference fit, [2] which is achieved by heating the ring gear and so that thermal expansion allows it to be placed around the flywheel.
1968–1969 Chevrolet Camaro (most were dealer installed, but in 1969 both the L-72 and the ZL-1 were factory options) 427 production codes: LS-1: produced 1969, 10.25:1 compression, Q-jet carburetor, oval port closed chamber heads, hydraulic lifters, nodular iron crankshaft, and two-bolt main caps. It produced 335 hp (250 kW). [37]