When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Collar beam - Wikipedia

   en.wikipedia.org/wiki/Collar_beam

   The simplest form of roof framing is a common rafter roof. This roof framing has nothing but rafters and a tie beam at the bottoms of the rafters. The next step in the development of roof framing was to add a collar, called a collar beam roof. Collar beam roofs are suitable for spans up to around (4.5 meters). [5]

3. Timber roof truss - Wikipedia

   en.wikipedia.org/wiki/Timber_roof_truss

   Key: 1: principal rafters, 2: collar beam, 3: arch braces. Lacking a tie beam, [11] the arch-braced (arched brace) [12] truss gives a more open look to the interior of the roof. The principal rafters are linked by a collar beam supported by a pair of arch braces, which stiffen the structure and help to transmit the weight of the roof down ...

4. Hammerbeam roof - Wikipedia

   en.wikipedia.org/wiki/Hammerbeam_roof

   A hammer-beam is a form of timber roof truss, allowing a hammerbeam roof to span greater than the length of any individual piece of timber.In place of a normal tie beam spanning the entire width of the roof, short beams – the hammer beams – are supported by curved braces from the wall, and hammer posts or arch-braces are built on top to support the rafters and typically a collar beam.

5. Rafter - Wikipedia

   en.wikipedia.org/wiki/Rafter

   Compass rafter: A rafter curved or bowed on the top (the top surface of a rafter is called its "back") or both the top and bottom surfaces. Curb rafter: The upper rafters in a curb (kerb, gambrel, Mansard roof) roof. Hip rafter (angle rafter): The rafter in the corners of a hip roof. The foot of a hip rafter lands on a dragon beam.

6. Domestic roof construction - Wikipedia

   en.wikipedia.org/wiki/Domestic_roof_construction

   This is accomplished by using metal ties fastened to each rafter or truss. This is not normally a problem in areas not prone to high wind or extreme weather conditions. In the UK, a concrete tiled roof would normally have rafters at 600 mm (24 in) centers, roof battens at 300 mm (12 in) centers and ceiling joists at 400 mm (16 in) centers.

7. Crown post - Wikipedia

   en.wikipedia.org/wiki/Crown_post

   Crown post roof in the solar at Old Soar Manor in 2009: the crown post is the upright above the tie beam. It carries a beam called the crown plate which in turn supports the collar beams. There are braces between the collar beams and common rafters and from the crown posts to these braces.