Ads
related to: 1 2 inch thick shiplap
Search results
Results From The WOW.Com Content Network
Shiplap is either rough-sawn 25 mm (1 in) or milled 19 mm (3 ⁄ 4 in) pine or similarly inexpensive wood between 76 and 254 mm (3 and 10 in) wide with a 9.5–12.7 mm (3 ⁄ 8 – 1 ⁄ 2 in) rabbet on opposite sides of each edge. [1] The rabbet allows the boards to overlap in this area.
Depending on the diameter of the log, cuts are made from 4 + 1 ⁄ 2 to 6 + 1 ⁄ 2 inches (110 to 170 mm) deep along the full length of the log. Each time the log turns for the next cut, it is rotated 5 ⁄ 8 inch (16 mm) until it has turned 360°. This gives the radially sawn clapboard its taper and true vertical grain.
It has walls 18 inches (46 cm) thick, which were originally sheathed with shiplap siding. A partial upper floor was originally illuminated by porthole windows; this was altered in the 1880s, when the roof was raised and sash windows were installed.
Each wall frame is covered in lath, tacked at the studs. Wood lath is typically about one inch (2.5 cm) wide by four feet (1.2 m) long by 1 ⁄ 4 inch (6 mm) thick. Each horizontal course of lath is spaced about 3 ⁄ 8 inch (9.5 mm) away from its neighboring courses. Metal lath is available in 27-inch (69 cm) by 8-foot (240 cm) sheets.
The board foot or board-foot is a unit of measurement for the volume of lumber in the United States and Canada [1]. It equals the volume of a board that is one foot (30.5 cm) in length, one foot in width, and one inch (2.54 cm) in thickness, or exactly 2.359 737 216 liters. Board foot can be abbreviated as FBM (for "foot, board measure"), BDFT ...
One example of such grooved plywood siding is the type called Texture 1–11, T1-11, or T111 ("tee-one-eleven"). There is also a product known as reverse board-and-batten RBB that looks similar but has deeper grooves. Some of these products may be thick enough and rated for structural applications if properly fastened to studs.