Search results
Results From The WOW.Com Content Network
The MIL can present a legend, such as check engine, power limited, engine, or service engine soon; or it also can present a pictogram of an engine. In hybrid and electric cars, a fault with the hybrid/EV system shows the pictogram of the vehicle with the exclamation point to indicate a fault with the electric motor and/or hybrid/EV battery (in ...
A check engine light or malfunction indicator lamp (MIL), is a tell-tale that a computerized engine-management system uses to indicate a malfunction or problem with the vehicle ranging from minor (such as a loose gas cap) to serious (worn spark plugs, engine problems or a faulty oil valve, etc.).
In a collision in which two young women in a Chevrolet Cobalt were killed when the ignition switch shut off the engine, GM only counted the death of the woman in the front seat, because the death of the woman in the back seat was not caused by the failure of the airbag to deploy. [16] Most of the victims were under age 25. [17]
Delco Electronics Corporation was the automotive electronics design and manufacturing subsidiary of General Motors based in Kokomo, Indiana, that manufactured Delco Automobile radios and other electric products found in GM cars. In 1972, General Motors merged it with the AC Electronics division and it continued to operate as part of the Delco ...
GM is potentially facing a large warranty issue as the National Highway Traffic Safety Administration (NHTSA) opened a preliminary investigation into engine failure affecting 877,710 GM SUVs and ...
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
Most engines require one or more systems to start and shut down the engine and to control parameters such as the power, speed, torque, pollution, combustion temperature, and efficiency and to stabilise the engine from modes of operation that may induce self-damage such as pre-ignition. Such systems may be referred to as engine control units.
They were built under the same premise that a lower power rating than the 4,400 hp (3,300 kW) rating of the Dash 9-44CW (or C44-9W) (see below) would prolong the life of the engine, and use less fuel. However, there is a manual override switch that allows the engineer to run the engine with all 4,400 hp (3,300 kW) if necessary.