Search results
Results From The WOW.Com Content Network
In a completed well, there may be many annuli. The 'A' annulus is the void between the production tubing and the smallest casing string. The 'A' annulus can serve a number of crucial tasks, including gas lift and well kills. A normal well will also have a 'B' and frequently a 'C' annulus, between the different casing strings.
Annular velocity is the speed of the drilling fluid's movement in a column called an annulus in oil wells. [1] It is commonly measured in feet per minute (ft/min) or meters per minute (m/min). Annular velocity is often abbreviated as AV, though this is not exclusively so, as AV also refers to apparent viscosity which is calculated from ...
Annular capacity (bbl/ft) = (ID hole 2 - OD pipe 2) / 1029.4. where ID hole 2 = Inside diameter of the casing or open hole in inches OD pipe 2 = Outside diameter of the pipe in inches. Similarly Annular volume (bbls) = Annular capacity (bbl/ft) × length (ft) and Feet occupied by volume of mud in annulus = Volume of mud (bbls) / Annular ...
In larger diameters, this annular pressure is small, rarely exceeding 200 psi (13.79 bar). In smaller diameters, it can be 400 psi (27.58 bar) or higher. Backpressure or pressure held on the choke further increases bottom hole pressure, which can be estimated by adding up all the known pressures acting in, or on, the annular (casing) side.
Using this term, one can calculate many things in the same way as for a round tube. When the cross-section is uniform along the tube or channel length, it is defined as [1] [2] =, where A is the cross-sectional area of the flow, P is the wetted perimeter of the cross-section.
A typical size of surface casing is 13 + 3 ⁄ 8 inches (340 mm). [5] Intermediate casing may be necessary on longer drilling intervals where necessary drilling mud weight to prevent blowouts may cause a hydrostatic pressure that can fracture shallower or deeper formations. Casing placement is selected so that the hydrostatic pressure of the ...
Production casing is the final casing string set in a well and usually reaches from the surface to Target Depth (TD). The type of casing used depends upon the different conditions in the well. Commonly, production casing sizes range from 4 + 1 ⁄ 2 in (110 mm) to as large as 9 + 5 ⁄ 8 in (240 mm). It is the last string cemented in a well ...
In a nozzle or other constriction, the discharge coefficient (also known as coefficient of discharge or efflux coefficient) is the ratio of the actual discharge to the ideal discharge, [1] i.e., the ratio of the mass flow rate at the discharge end of the nozzle to that of an ideal nozzle which expands an identical working fluid from the same initial conditions to the same exit pressures.