Search results
Results From The WOW.Com Content Network
An op amp without negative feedback (a comparator) The amplifier's differential inputs consist of a non-inverting input (+) with voltage V + and an inverting input (−) with voltage V −; ideally the op amp amplifies only the difference in voltage between the two, which is called the differential input voltage.
For transistors, the current-gain–bandwidth product is known as the f T or transition frequency. [4] [5] It is calculated from the low-frequency (a few kilohertz) current gain under specified test conditions, and the cutoff frequency at which the current gain drops by 3 decibels (70% amplitude); the product of these two values can be thought of as the frequency at which the current gain ...
The input offset voltage is a parameter defining the differential DC voltage required between the inputs of an amplifier, especially an operational amplifier (op-amp), to make the output zero (for voltage amplifiers, 0 volts with respect to ground or between differential outputs, depending on the output type).
In electronics engineering, frequency compensation is a technique used in amplifiers, and especially in amplifiers employing negative feedback.It usually has two primary goals: To avoid the unintentional creation of positive feedback, which will cause the amplifier to oscillate, and to control overshoot and ringing in the amplifier's step response.
Referring to the above diagram, if the op-amp is assumed to be ideal, then the voltage at the inverting (-) input is held equal to the voltage at the non-inverting (+) input as a virtual ground. The input voltage passes a current V in / R 1 {\displaystyle V_{\text{in}}/{R_{1}}} through the resistor producing a compensating current flow through ...
The open-loop gain of many electronic amplifiers is exceedingly high (by design) – an ideal operational amplifier (op-amp) has infinite open-loop gain. Typically an op-amp may have a maximal open-loop gain of around , or 100 dB. An op-amp with a large open-loop gain offers high precision when used as an inverting amplifier.
Figure 5: Op-amp differential amplifier. An operational amplifier, or op-amp, is a differential amplifier with very high differential-mode gain, very high input impedance, and low output impedance. An op-amp differential amplifier can be built with predictable and stable gain by applying negative feedback (Figure 5).
The gain of an amplifier is the ratio of output to input power or amplitude, and is usually measured in decibels.When measured in decibels it is logarithmically related to the power ratio: G(dB)=10 log(P out /P in).