When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Fire pit - Wikipedia

   en.wikipedia.org/wiki/Fire_pit

   A fire pit. The defining feature of fire pits is that they are designed to contain fire and prevent it from spreading. A fire pit can vary from a pit dug in the ground (fire hole) to an elaborate gas burning structure of stone, brick, and metal. Certain contemporary fire pit styles include fire bowls that can either be set in the ground or ...

3. Fireplace - Wikipedia

   en.wikipedia.org/wiki/Fireplace

   A fire is contained in a firebox or fire pit; a chimney or other flue allows exhaust gas to escape. A fireplace may have the following: a foundation, a hearth, a firebox, a mantel , a chimney crane (used in kitchen and laundry fireplaces), a grate, a lintel , a lintel bar, an overmantel , a damper , a smoke chamber, a throat, a flue, and a ...

4. Firebox (steam engine) - Wikipedia

   en.wikipedia.org/wiki/Firebox_(steam_engine)

   Some fireboxes were equipped with a so-called combustion chamber, this is a distinct component from the firebox and tubes - a large single extension of the firebox space, into the boiler barrel, and above the brick arch and separated from the grate and the fire bed, this placed additional space between the fire and the rear fire tube/flue sheet.

5. 35 Fire Pit Ideas to Completely Transform Your Outdoor Space

   www.aol.com/lifestyle/35-fire-pit-ideas...

   For premium support please call: 800-290-4726 more ways to reach us

6. Wall plug - Wikipedia

   en.wikipedia.org/wiki/Wall_plug

   Before commercial wall plugs, fixings were made to brick or masonry walls by first chiselling a groove into a soft mortar joint, hammering in a crude wooden plug and then attaching to the wooden plug. This was time consuming and required a large hole, thus more patching of the wall afterwards. It also limited the holes' location to the mortar ...

7. Plug and feather - Wikipedia

   en.wikipedia.org/wiki/Plug_and_feather

   A number of holes are then cut or drilled into the stone face along the scored line approximately 10 to 20 centimetres (3.9 to 7.9 in) apart. Plug and feather sets are inserted in the holes, with the "ears" of the feathers facing the direction of the desired split. The plugs are then struck with a hammer in sequence.