Search results
Results From The WOW.Com Content Network
A pulse-Doppler radar is a radar system that determines the range to a target using pulse-timing techniques, and uses the Doppler effect of the returned signal to determine the target object's velocity. It combines the features of pulse radars and continuous-wave radars, which were formerly separate due to the complexity of the electronics.
The distance resolution reachable with a linear frequency modulation of a pulse on a bandwidth is: 2 Δ f where is the speed of the wave. Definition. Ratio T T ′ = T Δ f {\textstyle {\frac {T} {T'}}=T\Delta f} is the pulse compression ratio. It is generally greater than 1 (usually, its value is 20 to 30).
The pulse width ( ) (or pulse duration) of the transmitted signal is the time, typically in microseconds, each pulse lasts. If the pulse is not a perfect square wave, the time is typically measured between the 50% power levels of the rising and falling edges of the pulse. The pulse width must be long enough to ensure that the radar emits ...
The radar mile is the time it takes for a radar pulse to travel one nautical mile, reflect off a target, and return to the radar antenna. Since a nautical mile is defined as 1,852 m, then dividing this distance by the speed of light (299,792,458 m/s), and then multiplying the result by 2 yields a result of 12.36 μs in duration.
Chirp compression. The chirp pulse compression process transforms a long duration frequency-coded pulse into a narrow pulse of greatly increased amplitude. It is a technique used in radar and sonar systems because it is a method whereby a narrow pulse with high peak power can be derived from a long duration pulse with low peak power.
Moving target indication (MTI) is a mode of operation of a radar to discriminate a target against the clutter. [1] It describes a variety of techniques used for finding moving objects, like an aircraft, and filter out unmoving ones, like hills or trees. It contrasts with the modern stationary target indication (STI) technique, which uses ...
Pulse-Doppler signal processing. Pulse-Doppler signal processing is a radar and CEUS performance enhancement strategy that allows small high-speed objects to be detected in close proximity to large slow moving objects. Detection improvements on the order of 1,000,000:1 are common. Small fast moving objects can be identified close to terrain ...
Continuous-wave radar (CW radar) is a type of radar system where a known stable frequency continuous wave radio energy is transmitted and then received from any reflecting objects. [1] Individual objects can be detected using the Doppler effect , which causes the received signal to have a different frequency from the transmitted signal ...