Ad
related to: end fed antenna wiring diagram on a 1969 cadillac
Search results
Results From The WOW.Com Content Network
A dipole can be fed from very near its end (needing to be only about 1 / 20 th of the dipole length from the actual end) but the end impedances are exceedingly high – a few thousands of ohms, depending on the average height of the antenna and thickness of its wire.
In antenna terms, each of the conductors making up the antenna is known as an element. [9] To calculate the net result, NEC breaks the antenna's elements into a number of sampled points, called segments. It uses simple calculations based on the diameter of the conductor and the wavelength of the signal to determine the induced voltage and ...
The antenna feed system or antenna feed is the cable or conductor, and other associated equipment, which connects the transmitter or receiver with the antenna and makes the two devices compatible. [ 1 ] [ 2 ] In a radio transmitter, the transmitter generates an alternating current of radio frequency , and the feed system feeds the current to ...
Often random wire antennas are also (inaccurately) referred to as long-wire antennas.There is no accepted minimum size, but actual long-wire antennas must be greater than at least a quarter-wavelength ( 1 / 4 λ) or perhaps greater than a half ( 1 / 2 λ) at the frequency the long wire antenna is used for, and even a half-wave may only be considered "long-ish" rather than "truly ...
The automatic power antenna became much more common in the 1970s. [ 1 ] On many Cadillac models of the 1950s and '60s, the antenna could be raised and lowered by pulling out or pushing in on the radio's volume control knob.
The J-pole antenna is an end-fed omnidirectional half-wave antenna that is matched to the feedline by a shorted quarter-wave parallel transmission line stub. [5] [1] [6] For a transmitting antenna to operate efficiently, absorbing all the power provided by its feedline, the antenna must be impedance matched to the line; it must have a resistance equal to the feedline's characteristic impedance.
The antenna feedpoint is usually high in the air (for example, a dipole antenna) or far away (for example, an end-fed random wire antenna). A transmission line, or feedline, must carry the signal between the transmitter and the antenna. The ATU can be placed anywhere along the feedline: at the transmitter, at the antenna, or somewhere in between.
The trideco antenna is a huge specialized umbrella antenna used in a few high power military transmitters at very low frequency (VLF). [5] [6] In a conventional umbrella antenna, the use of the sloping guy wires as the capacitive top load has some disadvantages: First, since the umbrella wires must be anchored to the ground, their length is ...