When.com Web Search

  1. Ads

    related to: three position toggle momentary switch schematic

Search results

  1. Results From The WOW.Com Content Network
  2. Multiway switching - Wikipedia

    en.wikipedia.org/wiki/Multiway_switching

    Instead of running mains voltage to the switches, a low voltage—typically 24 V AC—is connected to remote momentary toggle or rocker switches. The momentary switches usually have SPDT contacts in an (ON)-OFF-(ON) configuration. Pushing the switch actuator in one direction causes the relay contacts to close; pushing it in the opposite ...

  3. Push switch - Wikipedia

    en.wikipedia.org/wiki/Push_switch

    A push switch (button) is a momentary or non-latching switch which causes a temporary change in the state of an electrical circuit only while the switch is physically actuated. An automatic mechanism (i.e. a spring ) returns the switch to its default position immediately afterwards, restoring the initial circuit condition.

  4. Switch - Wikipedia

    en.wikipedia.org/wiki/Switch

    A toggle DIP switch with four inputs and outputs Bank of toggle switches on a Data General Nova minicomputer front panel Toggle switches with the shared cover preventing certain forbidden combinations. A toggle switch or tumbler switch is a class of electrical switches that are manually actuated by a mechanical lever, handle, or rocking mechanism.

  5. Ladder logic - Wikipedia

    en.wikipedia.org/wiki/Ladder_logic

    The key to understanding the latch is in recognizing that the "Start" switch is a momentary switch (once the user releases the button, the switch is open again). As soon as the "Run" solenoid engages, it closes the "Run" NO contact, which latches the solenoid on. The "Start" switch opening up then has no effect.

  6. Texas Instruments SN76477 - Wikipedia

    en.wikipedia.org/wiki/Texas_Instruments_SN76477

    SW1 is a five position rotary switch that selects which capacitor controls the one-shot circuit that sets the envelope timing. SW24 (toggle or momentary) is the one-shot trigger switch, closed position is active. R1 a one megohm linear potentiometer sets the actual one-shot timing (in series with fixed 27k resistor R2) within the range selected ...

  7. Magnetic starter - Wikipedia

    en.wikipedia.org/wiki/Magnetic_starter

    As a result, magnetic starters often use momentary switches for "off" and "on" functions, as this type of switch returns to a defined normal position when released. Latching switches do not have this feature and therefore are normally not used with a magnetic starter. Motor control contactors can be fitted with short-circuit protection (fuses ...