Search results
Results From The WOW.Com Content Network
Up to a temperature of 0.01 °C, the triple point of water, water normally exists as ice, except for supercooled water, for which one data point is tabulated here. At the triple point, ice can exist together with both liquid water and vapor. At higher temperatures, the data are for water vapor only.
The increase observed for water from 0 °C (32 °F) to 3.98 °C (39.16 °F) and for a few other liquids [d] is described as negative thermal expansion. Regular, hexagonal ice is also less dense than liquid water—upon freezing, the density of water decreases by about 9%. [36] [e]
Density of pure water at 60 °F = / or / [8] Note: There is no universal agreement on the exact density of pure water at various temperatures since each industry will often use a different standard. For example the, USGS says it is 0.99907 g/cm 3 . [ 9 ]
Density (g cm-3) Boiling point (°C) K b (°C⋅kg/mol) Freezing point (°C) K f (°C⋅kg/mol) Data source; Aniline: 184.3 3.69 –5.96 –5.87 K b & K f [1] Lauric acid: 298.9 44 –3.9 Acetic acid: 1.04 117.9 3.14 16.6 –3.90 K b [1] K f [2] Acetone: 0.78 56.2 1.67 –94.8 K b [3] Benzene: 0.87 80.1 2.65 5.5 –5.12 K b & K f [2 ...
It freezes at a lower temperature (about −1.9 °C (28.6 °F)) and its density increases with decreasing temperature to the freezing point, instead of reaching maximum density at a temperature above freezing. The salinity of water in major seas varies from about 0.7% in the Baltic Sea to 4.0% in the Red Sea.
Specific gravity for solids and liquids is nearly always measured with respect to water at its densest (at 4 °C or 39.2 °F); for gases, the reference is air at room temperature (20 °C or 68 °F). The term "relative density" (abbreviated r.d. or RD) is preferred in SI, whereas the term "specific gravity" is gradually being abandoned. [3]
Baumé degrees (heavy) originally represented the percent by mass of sodium chloride in water at 60 °F (16 °C). Baumé degrees (light) was calibrated with 0 °Bé (light) being the density of 10% NaCl in water by mass and 10 °Bé (light) set to the density of water. Consider, at near room temperature:
At max. saturation (i. e. rel. humidity = 100% at 0 °C) the density will go down to 28.51 g/mol. STP conditions imply a temperature of 0 °C, at which the ability of water to become vapor is very restricted. Its concentration in air is very low at 0 °C. The red line on the chart to the right is the maximum concentration of water vapor ...