When.com Web Search

  1. Ads

    related to: usb cable with female end of line diagram images

Search results

  1. Results From The WOW.Com Content Network
  2. Gender of connectors and fasteners - Wikipedia

    en.wikipedia.org/wiki/Gender_of_connectors_and...

    Schematic symbols for male and female connector pins. In electrical and mechanical trades and manufacturing, each half of a pair of mating connectors or fasteners is conventionally designated as male or female, [1] a distinction referred to as its gender. [2] The female connector is generally a receptacle that receives and holds the male connector.

  3. USB hardware - Wikipedia

    en.wikipedia.org/wiki/USB_hardware

    Thus, USB cables have different ends: A and B, with different physical connectors for each. Each format has a plug and receptacle defined for each of the A and B ends. A USB cable, by definition, has a plug on each end—one A (or C) and one B (or C)—and the corresponding receptacle is usually on a computer or electronic device.

  4. USB - Wikipedia

    en.wikipedia.org/wiki/USB

    USB 3.2, released in September 2017, [38] preserves existing USB 3.1 SuperSpeed and SuperSpeedPlus architectures and protocols and their respective operation modes, but introduces two additional SuperSpeedPlus operation modes (USB 3.2 Gen 1×2 and USB 3.2 Gen 2×2) with the new USB-C Fabric with signaling rates of 10 and 20 Gbit/s (raw data ...

  5. File:MHL Micro-USB - HDMI wiring diagram.svg - Wikipedia

    en.wikipedia.org/wiki/File:MHL_Micro-USB_-_HDMI...

    You are free: to share – to copy, distribute and transmit the work; to remix – to adapt the work; Under the following conditions: attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made.

  6. USB-C - Wikipedia

    en.wikipedia.org/wiki/USB-C

    Whereas earlier USB cables had a host end A and a peripheral device end B, a USB-C cable connects either way; and for interoperation with older equipment, there are cables with a Type-C plug at one end and either a Type-A (host) or a Type-B (peripheral device) plug at the other. The designation "C" refers only to the connector's physical ...

  7. USB communications - Wikipedia

    en.wikipedia.org/wiki/USB_communications

    A USB device pulls one of the data lines high with a 1.5 kΩ resistor. This overpowers one of the 15 kΩ pull-down resistors in the host and leaves the data lines in an idle state called J. For USB 1.x, the choice of data line indicates what signal rates the device is capable of: full-bandwidth devices pull D+ high,