Search results
Results From The WOW.Com Content Network
A typical spring-loaded solder sucker A solder sucker partially dismantled showing the spring. A desoldering pump, colloquially known as a solder sucker, is a manually-operated device which is used to remove solder from a printed circuit board.
The defining characteristic of a wiped joint is that the soldering process involves mechanically working or 'wiping' the joint. [1] As well as heating solder and applying it to the joint, the solder is shaped into place manually, wiping it with a non-metallic tool to form a smooth-surfaced outer shape.
Pipe classes and piping line numbers; Flow directions; Interconnections references; Permanent start-up, flush and bypass lines; Pipelines and flowlines; Blinds and spectacle blinds; Insulation and heat tracing; Process control instrumentation and designation (names, numbers, unique tag identifiers), including:
Process piping and power piping are typically checked by pipe stress engineers to verify that the routing, nozzle loads, hangers, and supports are properly placed and selected such that allowable pipe stress is not exceeded under different loads such as sustained loads, operating loads, pressure testing loads, etc., as stipulated by the ASME B31, EN 13480, GOST 32388, RD 10-249 or any other ...
In fluid mechanics, plug flow is a simple model of the velocity profile of a fluid flowing in a pipe. In plug flow, the velocity of the fluid is assumed to be constant across any cross-section of the pipe perpendicular to the axis of the pipe. The plug flow model assumes there is no boundary layer adjacent to the inner wall of the pipe.
Both pipe and tube imply a level of rigidity and permanence, whereas a hose is usually portable and flexible. A tube and pipe may be specified by standard pipe size designations, e.g., nominal pipe size, or by nominal outside or inside diameter and/or wall thickness. The actual dimensions of pipe are usually not the nominal dimensions: A 1-inch ...
The tremie concrete placement method uses a vertical or nearly vertical pipe, through which concrete is placed by gravity feed below water level. [4]The lower end of the pipe is kept immersed in fresh concrete so that concrete rising from the bottom displaces the water above it, thus limiting washing out of the cement content of the fresh concrete at the exposed upper surface.
Tube beading is a metal forming process that forms a bead on the end of a tube. Tube beads can be used to help hold a hose on the end of a tube or to strengthen the end of the tube. [ 1 ] There are two forming processes: internal roll forming and ram forming .