Search results
Results From The WOW.Com Content Network
A stroke is the action of a piston travelling the full length of its cylinder.In a two-stroke engine, one of the two strokes combines primarily the intake stroke and the combustion stroke, while the other stroke primarily combines the compression stroke and the exhaust stroke, though technically since both ports are exposed during both the combustion and compression strokes, some reversion ...
A cylinder head of a four valve Nissan VQ engine engine. A multi-valve or multivalve engine is one where each cylinder has more than two valves (an intake, and an exhaust).A multi-valve engine has better breathing, and with more smaller valves (having less mass in motion) may be able to operate at higher revolutions per minute (RPM) than a two-valve engine, delivering more power.
Ford later used versions of the DOHC 4-valve 5.4 L in the 2000 Ford Mustang SVT Cobra R, the Ford GT supercar, and the Ford Shelby GT500. The DOHC 4-valve 5.4 L was also used in the Ford Falcon line in Australia under the Boss moniker until 2010, when it was replaced by a locally developed, supercharged version of the 5.0 litre Modular V8.
Cutaway of a dual overhead camshaft engine 1969 AMC V8 overhead valve engine. The rocker cover has been removed, so the pushrods, rocker arms, valve springs, and valves are visible. A valvetrain is a mechanical system that controls the operation of the intake and exhaust valves in an internal combustion engine. [1]
The dual-mode exhaust uses vacuum-actuated outlet valves, which control engine noise during low-load operation, but open for maximum performance during high-load operation. The system is similar to the C6 Z06, but uses a 2.5 in (64 mm) diameter exhaust compared to the Z06's 3 in (76.2 mm).
Ordinary valves can have many ports and fluid paths. A 2-way valve, for example, has 2 ports; if the valve is open, then the two ports are connected and fluid may flow between the ports; if the valve is closed, then ports are isolated. If the valve is open when the solenoid is not energized, then the valve is termed normally open (N.O.).
Ilmor's prototype, intended for motorcycle use and consisting of 2 primary cylinders and 1 secondary cylinder, uses a solid cylinder block with electrically driven oil and water pumps, two overhead camshafts with standard poppet valves, and turbocharging. Its displacement is 700 cc (43 cu in) without the secondary cylinder and 1,478 cc (90.2 cu ...
The solenoid valve regulates the amount of oil pumped by the cam action to either the valve or a bypass reservoir. When pressurized, the hydraulic line behaves like a solid body and transmits the lift schedule imparted by the intake cam directly to the intake valve. When the solenoid is disengaged, a spring takes over valve actuation duties.