Search results
Results From The WOW.Com Content Network
To maintain the balance, circuit blocks which interface to the line or are connected in the line must also be balanced. Balanced lines work because the interfering noise from the surrounding environment induces equal noise voltages into both wires. By measuring the voltage difference between the two wires at the receiving end, the original ...
A water detector is an electronic device that is designed to detect the presence of water for purposes such as to provide an alert in time to allow the prevention of water leakage. A common design is a small cable or device that lies flat on a floor and relies on the electrical conductivity of water to decrease the resistance across two contacts.
These three components complete a full circuit for a signal to travel through and the impedances of this circuit is what determines whether the interface as a whole is balanced or not: [3] "A balanced circuit is a two-conductor circuit in which both conductors and all circuits connected to them have the same impedance to ground and to all other ...
A typical water meter register showing a meter reading of 8.3 gallons. Notice the black "1" on the odometer has not yet fully turned over, so only the red hand is read. Water meters connected to remote reading devices through three-wire cables. There are several types of registers on water meters.
Balancing limits the flow in favoured circuits, forcing water through unfavored circuits. As a result, the required design flows are available to all circuits and the system can provide the required indoor air quality. Avoiding overflows means the pump is not doing unnecessary work which saves energy, reduces operating cost and can reduce the ...
A digital readout integrated circuit (DROIC) is a class of ROIC that uses on-chip analog-to-digital conversion (ADC) to digitize the accumulated photocurrent in each pixel of the imaging array. DROICs are easier to integrate into a system compared to ROICs as the package size and complexity are reduced, they are less sensitive to noise and have ...
Electronic filter topology defines electronic filter circuits without taking note of the values of the components used but only the manner in which those components are connected. Filter design characterises filter circuits primarily by their transfer function rather than their topology. Transfer functions may be linear or nonlinear.
A variation of magnetic sensing is the "Hall effect" sensor which utilizes the magnetic sensing of a mechanical gauge's indications. In a typical application, a magnetism-sensitive "Hall effect sensor" is affixed to a mechanical tank gauge that has a magnetized indicator needle, so as to detect the indicating position of the gauge's needle.