Ads
related to: ridge beam and rafter system for construction buildings cost
Search results
Results From The WOW.Com Content Network
Hip rafter (angle rafter): The rafter in the corners of a hip roof. The foot of a hip rafter lands on a dragon beam. King rafter: the longest rafter on the side of a hip roof in line with the ridge. Valley rafter (historically also called a sleeper): A rafter forming a valley (look for illustration showing a valley). Intermediate rafter: "one ...
Domestic roof construction is the framing and roof covering which is found on most detached houses in cold and temperate climates. [1] Such roofs are built with mostly timber , take a number of different shapes , and are covered with a variety of materials .
Two king post trusses linked to support a roof. Key:1: ridge beam, 2: purlins, 3: common rafters. This is an example of a "double roof" with principal rafters and common rafters. A timber roof truss is a structural framework of timbers designed to bridge the space above a room and to provide support for a roof.
Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a
Vigas were often spaced 3 feet (0.91 m) apart, although irregular or unequal spaced was characteristic of Spanish colonial architecture. Buildings using viga roof construction vary from large institutional buildings to small ones. The amount of vigas used for a room vary, but six was the standard.
A hammer-beam is a form of timber roof truss, allowing a hammerbeam roof to span greater than the length of any individual piece of timber.In place of a normal tie beam spanning the entire width of the roof, short beams – the hammer beams – are supported by curved braces from the wall, and hammer posts or arch-braces are built on top to support the rafters and typically a collar beam.