Ads
related to: frequency hopping in gsm router data center
Search results
Results From The WOW.Com Content Network
Using frequency hopping and sweep modes, Zinn's method is primarily applied in low data rate wireless applications such as utility metering, machine and equipment monitoring and metering, and remote control. In 2006 Zinn received U.S. patent 6,996,399 for his "Wireless device and method using frequency hopping and sweep modes."
A hopping sequence is followed by the TRXs and handsets using the sector. Several hopping sequences are available, and the sequence in use for a particular cell is continually broadcast by that cell so that it is known to the handsets. A TRX transmits and receives according to the GSM standards, which specify eight TDMA timeslots per radio ...
GSM radio frequency optimization (GSM RF optimisation) is the optimization of GSM radio frequencies. GSM networks consist of different cells and each cell transmit signals to and receive signals from the mobile station, for proper working of base station many parameters are defined before functioning the base station such as the coverage area of a cell depends on different factors including ...
The Radio Frequency Block sends and receives signals to/from portable devices (via the air interface) and converts between digital data and antenna signal. Some of the main functions are D/A and A/D conversion, up/down conversion, carrier selection, linear power amplification, diversity transmit and receive, RF combining and RF filtering.
For mobile phone technology, a mobile allocation index offset (MAIO) refers a time delay separating traffic channels.When a GSM (Global System for Mobile Communications) mobile phone is served by a cell that is hopping over a set of frequencies, the separate traffic channels hop over the allocated frequencies according to a hopping sequence number (HSN).
Code-division multiplexing (CDM), code-division multiple access (CDMA) or spread spectrum is a class of techniques where several channels simultaneously share the same frequency spectrum, and this spectral bandwidth is much higher than the bit rate or symbol rate. One form is frequency hopping, another is direct sequence spread spectrum.
In PCIe, USB 3.0, and SATA systems, the most common technique is downspreading, via frequency modulation with a lower-frequency source. [8] Spread-spectrum clocking, like other kinds of dynamic frequency change, can also create challenges for designers. Principal among these is clock/data misalignment, or clock skew.
Bluetooth devices intended for use in short-range personal area networks operate from 2.4 to 2.4835 GHz. To reduce interference with other protocols that use the 2.45 GHz band, the Bluetooth protocol divides the band into 80 channels (numbered from 0 to 79, each 1 MHz wide) and changes channels up to 1600 times per second.