Ads
related to: how to make a small vacuum pump 120v
Search results
Results From The WOW.Com Content Network
A vacuum ejector, or simply ejector, or aspirator, is a type of vacuum pump, which produces vacuum by means of the Venturi effect.. In an ejector, a working fluid (liquid or gaseous) flows through a jet nozzle into a tube that first narrows and then expands in cross-sectional area.
The sorption pump is a cyclic pump and its cycle has 3 phases: sorption, desorption and regeneration. In the sorption phase the pump is actually used to create a vacuum. . This is achieved by cooling the pump body to low temperatures, typically by immersing it in a Dewar flask filled with liquid nitro
In the field of oil regeneration and re-refining, vacuum pumps create a low vacuum for oil dehydration and a high vacuum for oil purification. [44] A vacuum may be used to power, or provide assistance to mechanical devices. In hybrid and diesel engine motor vehicles, a pump fitted on the engine (usually on the camshaft) is used to produce a vacuum.
A pump of this type is capable of producing high vacuum in which the pressure is 1 mPa. [1] The Sprengel pump is a vacuum pump that uses drops of mercury falling through a small-bore capillary tube to trap air from the system to be evacuated. [Note 1] It was invented by Hanover-born chemist Hermann Sprengel in 1865 while he was working in ...
A cryopump or a "cryogenic pump" is a vacuum pump that traps gases and vapours by condensing them on a cold surface, but are only effective on some gases. The effectiveness depends on the freezing and boiling points of the gas relative to the cryopump's temperature.
Single-stage vacuum pumps typically produce vacuum to 35 torr (mm Hg) or 47 millibars (4.7 kPa), and two-stage pumps can produce vacuum to 25 torr, assuming air is being pumped and the ring-liquid is water at 15 °C (59 °F) or less. Dry air and 15 °C sealant-water temperature is the standard performance basis, which most manufacturers use for ...