Search results
Results From The WOW.Com Content Network
Orthographic projection (also orthogonal projection and analemma) [a] is a means of representing three-dimensional objects in two dimensions.Orthographic projection is a form of parallel projection in which all the projection lines are orthogonal to the projection plane, [2] resulting in every plane of the scene appearing in affine transformation on the viewing surface.
An example of a multiview orthographic drawing from a US Patent (1913), showing two views of the same object. Third angle projection is used. In third-angle projection , the object is conceptually located in quadrant III, i.e. it is positioned below and behind the viewing planes, the planes are transparent , and each view is pulled onto the ...
It does so without the need for adjacent orthographic views and therefore may seem to render the circuitous, stepping protocol of Descriptive Geometry obsolete. However, since descriptive geometry is the science of the legitimate or allowable imaging of three or more dimensional space, on a flat plane, it is an indispensable study, to enhance ...
His work set the ground for orthographic projection which is one of the core techniques to be used in technical drawing today. Monge's methods were disseminated initially as a military secret, then far and wide, and his methods shaped the future of engineering education, and also the engineering practice.
This practice continued through the Eleventh Edition. Text-Films for the Seventh Edition: McGraw-Hill Text-Films For Engineering Drawing (10 min, According to Plan: Introduction to Engineering Drawing), For Chap. 1 McGraw-Hill Text-Films For Engineering Drawing (20 min, Orthographic Projection), For Chaps. 6 and 7
Classification of Axonometric projection and some 3D projections "Axonometry" means "to measure along the axes". In German literature, axonometry is based on Pohlke's theorem, such that the scope of axonometric projection could encompass every type of parallel projection, including not only orthographic projection (and multiview projection), but also oblique projection.
But, as the engineer projection and the standard isometry are scaled orthographic projections, the contour of a sphere is a circle in these cases, as well. As the diagram shows, an ellipse as the contour of a sphere might be confusing, so, if a sphere is part of an object to be mapped, one should choose an orthogonal axonometry or an engineer ...
ISO 128-44:2001 Technical drawings — General principles of presentation — Part 44: Sections on mechanical engineering drawings ISO 128-50:2001 Technical drawings — General principles of presentation — Part 50: Basic conventions for representing areas on cuts and sections