Ads
related to: radiator cap pressure cooling system
Search results
Results From The WOW.Com Content Network
A calibrated pressure-relief valve is usually incorporated in the radiator's fill cap. This pressure varies between models, but typically ranges from 4 to 30 psi (30 to 200 kPa). [4] As the coolant system pressure increases with a rise in temperature, it will reach the point where the pressure relief valve allows excess pressure to escape.
4.4 Engine cooling system. 4.5 Engine oil systems. 4.6 Exhaust system. 4.7 Fuel supply system. ... Radiator gasket; Radiator pressure cap; Overflow tank; Thermostat ...
The temperature of the cooling air may range from well below freezing to 50 °C. Further, while engines in long-haul boat or rail service may operate at a steady load, road vehicles often see widely varying and quickly varying load. Thus, the cooling system is designed to vary cooling so the engine is neither too hot nor too cold.
Proper engine coolant and a pressurized coolant system obviate these shortcomings of water. With proper antifreeze, a wide temperature range can be tolerated by the engine coolant, such as −34 °F (−37 °C) to +265 °F (129 °C) for 50% (by volume) propylene glycol diluted with distilled water and a 15 psi pressurized coolant system.
The North American P-51 Mustang makes significant use of the Meredith effect in its belly radiator design. [1]The Meredith effect is a phenomenon whereby the aerodynamic drag produced by a cooling radiator may be offset by careful design of the cooling duct such that useful thrust is produced by the expansion of the hot air in the duct.
The breather is often located in the oil cap. Many breathers had a cup or scoop and were located in the air stream of the engine radiator fan. This type of system is called "Pressure-Suction" type and air is forced into the scoop of the breather and by vacuum is draw out by the road draft tube.