When.com Web Search

  1. Ads

    related to: valve stem hole sizes

Search results

  1. Results From The WOW.Com Content Network
  2. Valve stem - Wikipedia

    en.wikipedia.org/wiki/Valve_stem

    Presta valves (also called Sclaverand valves or French valves) are normally only used on bicycles. The stem has a narrower diameter (nominally 6 mm) than the thinnest (nominally 8 mm) Schrader type, and so the bore of the hole in the rim through which the stem passes can be smaller. Has a locknut that needs to be opened to inflate/deflate. [17 ...

  3. Presta valve - Wikipedia

    en.wikipedia.org/wiki/Presta_valve

    It has a narrower diameter of 6 mm (0.24 in), compared to Dunlop and Schrader valves, measuring 8 mm (0.31 in). The weakest point of a bicycle rim is usually the hole for the valve stem. The smaller hole for a Presta valve makes it possible to have extremely narrow wheels while maintaining sufficient strength in the wheel.

  4. Schrader valve - Wikipedia

    en.wikipedia.org/wiki/Schrader_valve

    The Schrader valve consists of a valve stem into which a valve core is threaded. The valve core is a poppet valve assisted by a spring. A small rubber seal located on the core keeps the fluid from escaping through the threads. Using the appropriate tools, a faulty valve core can be immediately extracted from the valve stem and replaced with a ...

  5. Dunlop valve - Wikipedia

    en.wikipedia.org/wiki/Dunlop_valve

    The Dunlop valve, (also called a Woods valve, an English valve or a Blitz valve [1]) is a type of pneumatic valve stem in use—mostly on inner tubes of bicycles—in many countries, including Japan, [2] Korea, India, Pakistan, Sri Lanka, most European countries, and a number of developing countries.

  6. Poppet valve - Wikipedia

    en.wikipedia.org/wiki/Poppet_valve

    It consists of a hole or open-ended chamber, usually round or oval in cross-section, and a plug, usually a disk shape on the end of a shaft known as a valve stem. The working end of this plug, the valve face, is typically ground at a 45° bevel to seal against a corresponding valve seat ground into the rim of the chamber being sealed.

  7. Ball valve - Wikipedia

    en.wikipedia.org/wiki/Ball_valve

    A ball valve is a flow control device which uses a hollow, perforated, and pivoting ball to control fluid flowing through it. It is open when the hole through the middle of the ball is in line with the flow inlet and closed when it is pivoted 90 degrees by the valve handle, blocking the flow. [1]