Search results
Results From The WOW.Com Content Network
The concept of permeability is of importance in determining the flow characteristics of hydrocarbons in oil and gas reservoirs, [4] and of groundwater in aquifers. [5]For a rock to be considered as an exploitable hydrocarbon reservoir without stimulation, its permeability must be greater than approximately 100 md (depending on the nature of the hydrocarbon – gas reservoirs with lower ...
The porosity of a rock, or sedimentary layer, is an important consideration when attempting to evaluate the potential volume of water or hydrocarbons it may contain. Sedimentary porosity is a complicated function of many factors, including but not limited to: rate of burial, depth of burial, the nature of the connate fluids , the nature of ...
Formation testing is the only tool that can directly measure a rock formation's permeability down a well. [9] In case of its absence, which is common in most cases, an estimate for permeability can be derived from empirical relationships with other measurements such as porosity, NMR and sonic logging.
Once a possible hydrocarbon reservoir is identified, the key physical characteristics of a reservoir that are of interest to a hydrocarbon explorationist are its bulk rock volume, net-to-gross ratio, porosity and permeability. [2] Bulk rock volume, or the gross rock volume of rock above any hydrocarbon-water contact, is determined by mapping ...
in which is the absolute permeability, is the relative permeability, φ is the porosity, and μ is the fluid viscosity. Rocks with better fluid dynamics (i.e., experiencing a lower pressure drop in conducting a fluid phase) have higher TEM versus saturation curves.
Compactions and cementation generally lead to permeability reduction by losing porosity. [1] When a large region, which consist a fault zone, experience compaction and cementation, porosity loss in host rock (undeformed rock surrounding the fault zone) can be greater than that of fault zone rock. Hence, fluids are forced to flow through a fault ...
Porosity that is not considered "effective porosity" includes water bound to clay particles (known as bound water) and isolated "vuggy" porosity (vugs not connected to other pores, or dead-end pores). The effective porosity is of great importance in considering the suitability of rocks or sediments as oil or gas reservoirs, or as aquifers.
where is void ratio, is porosity, V V is the volume of void-space (air and water), V S is the volume of solids, and V T is the total or bulk volume of medium. [1] The significance of the porosity is that it gives the idea of water storage capacity of the aquifer. Qualitatively, porosity less than 5% is considered to be small, between 5 and 20% ...